Kroozin Menace Donating Members 1,990 Member For: 13y 9m 8d Gender: Male Location: Sydney Posted 15/09/11 04:07 AM Share Posted 15/09/11 04:07 AM (edited) I had similar mods at 18lb and made 320 in a manual Edited 15/09/11 04:10 AM by Kroozin Link to comment Share on other sites More sharing options...
xr6t_ute Donating Members 2,281 Member For: 17y 7m 4d Gender: Male Location: south east suburbs Posted 15/09/11 04:12 AM Share Posted 15/09/11 04:12 AM (edited) Its a hub dyno, of course it will show alot more power. Im running the std crossover still, and will never see those figures ,let alone with a Monza cooler on a dynamics dyno in shootf6 mode.Youll be lucky to come even close to 300 on a dynamics dyno. Edited 15/09/11 04:13 AM by xr6t_ute Link to comment Share on other sites More sharing options...
FORDCRAZY Member 36 Member For: 13y 9m 9d Posted 15/09/11 04:15 AM Author Share Posted 15/09/11 04:15 AM I h8toads, yeah I believe that dyno run on diff dyno will give diff result and I agree 330-340rwkw might be more accurate. Kroozin, yeah spins up too easily. Didn't in 3rd cause but I was trying different modes to try and get traction. Keeping in mind it was first drag event opening and track condition was bad. Next mods to get me 11s which wot I'm chasing and should with current tune. Is plazmaman or PW IC ( to suit standard piping) zf tune and M/T's this should improve times dramatically Link to comment Share on other sites More sharing options...
FORDCRAZY Member 36 Member For: 13y 9m 9d Posted 15/09/11 04:35 AM Author Share Posted 15/09/11 04:35 AM Xr6t ute, itll be well over 300rwkw, it previously made 313 on a dynamics dyno, with 12psi and stock exhaust section (from turbo to cat) now has 4" dump, and I went to gti performance cause I know he does very good safe tunes, and it proved worthwhile. No revelance to discussion but my car is ex cop car Link to comment Share on other sites More sharing options...
discostig Manual mode ________________________ All day, erryday Donating Members 13,798 Member For: 17y 2m 5d Gender: Male Location: Probably above atmospheric pressure Posted 15/09/11 05:00 AM Share Posted 15/09/11 05:00 AM (edited) 1/4 mile times and mph seem about right for the before run on the XFT tune. Impressive for monza cooler, does it heatsoak much if you run it again?I'm a good comparison as I'm running 42lb, nizpro cooler and replacement cold side to stock crossover, 3.5" dump on twin 2.5" manta exhaust, intank walkbro GSS294. 15PSI quite flat from around 3000rpm , see pichttp://i239.photobucket.com/albums/ff91/phyber83/The%20T/Phone032.jpg317rwkw on Simon's dyno, ran 11.94@120mph on 235/45/17" KU31's, PB. 2.09 60 foot.Soon to get some Nitto Invo's on the rear and try for a PB again Lower treadwear rating than KU31's though, 260 instead of 340 I think.Would like to get mine engine dynod to see what it's putting out before drivetrain losses but it'll never happen Oh and I'm also ex cop car owner. Your isn't lightning strike is it? hahaha. Edited 15/09/11 05:07 AM by -SteveR- Link to comment Share on other sites More sharing options...
f6mark Member 2,908 Member For: 13y 11m 15d Gender: Male Posted 15/09/11 05:06 AM Share Posted 15/09/11 05:06 AM nice.. Link to comment Share on other sites More sharing options...
IH8TOADS Silver Donating Members 3,618 Member For: 19y 6m 21d Gender: Male Location: OZ Posted 15/09/11 05:40 AM Share Posted 15/09/11 05:40 AM Being a hub dyno I can understand the power figure and he has done well to get there.In regards to your 'safe' comment.....I wouldn't take a 4sp auto there to get tuned! Link to comment Share on other sites More sharing options...
Kroozin Menace Donating Members 1,990 Member For: 13y 9m 8d Gender: Male Location: Sydney Posted 15/09/11 05:45 AM Share Posted 15/09/11 05:45 AM didnt realise hub dyno's inflated the figures so much Link to comment Share on other sites More sharing options...
IH8TOADS Silver Donating Members 3,618 Member For: 19y 6m 21d Gender: Male Location: OZ Posted 15/09/11 06:00 AM Share Posted 15/09/11 06:00 AM The MPH indicates good power for the mods :-) Link to comment Share on other sites More sharing options...
FORDCRAZY Member 36 Member For: 13y 9m 9d Posted 15/09/11 06:13 AM Author Share Posted 15/09/11 06:13 AM (how do I post pics via iPhone ?) SteveR, na I can't say it heat soaks at drags, it's fairly consistante with power delivery.cause there is atleast 15-20min between each pass. And mine is white with blue side stripes. Ih8toads, did u mean not take 4sp to gti or on dyno hub? And why? Although mine zf 6 sp I'm curious. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now