Jump to content

Do I Need Anymore Supporting Mods? And What Rwkw Would I Make?


Recommended Posts

  • Member
  • Member For: 15y 1m
  • Gender: Male
  • Location: Rhodes, Sydney.

Hey guys. Currently pulling 311rwkw in my 2005 BA xr6t ute (6 speed).

Seeing the tuner in 2 weeks and the excitement has kicked in and I would like to know if there's any more supporting mods I need before hand?? Not that I don't trust them I just like to hear it 2nd hand.

And secondly, what rwkw will I roughly b at???

I already have the following mods in place:

3.5 inch stainless exhaust (xforce)

High flow cat

Bigger injectors

Heavier duty valve springs

Exedy twin plate clutch

Xcal

Bov

Custom tune

20 inch wheels.

And the followings mods purchased:

1000hp plazmaman intercooler

Plazmaman hot and cold piping

Plazmaman 4" airbox kit

Fuel pump

Actuator

Battery re- location (still not sure boot/ passenger side

Any extra adice will be greatly appreciated as this is my pride and joy

Cheers.

  • Replies 27
  • Created
  • Last Reply

Top Posters In This Topic

  • Member
  • Member For: 15y 1m
  • Gender: Male
  • Location: Rhodes, Sydney.
  On 09/08/2011 at 9:50 AM, RowdyBurns said:

Which XCal have you got?

Mate just had a look. It is a SCT X3.

  • Donating Members
  • Member For: 15y 10m 29d
  • Gender: Male

wastegate ported and stronger actuator? have you got a big dump pipe?

edit: see you already have actuator

Edited by possum
  • Member
  • Member For: 15y 1m
  • Gender: Male
  • Location: Rhodes, Sydney.
  On 09/08/2011 at 10:04 AM, possum said:

wastegate ported and stronger actuator? have you got a big dump pipe?

edit: see you already have actuator

Not sure mate about the dump pipe my brother has borrowed the

Car so il have a look tomorrow.How much does it roughly cost

To get the wastegate ported??

  • Donating Members
  • Member For: 17y 1m 13d
  • Gender: Male
  • Location: Brisbane

Fitted an aftermarket turbo oil supply line?

That's going to be a nice setup when it all comes together, throw a pic up of your ute.

  • Three pedals are better then two..
  • Donating Members
  • Member For: 17y 10m 26d
  • Gender: Male
  • Location: Melbourne

I'd budget for an engine rebuild if the weak BA bottom end lets goes with the new power.

  • Member
  • Member For: 15y 1m
  • Gender: Male
  • Location: Rhodes, Sydney.
  On 09/08/2011 at 10:42 AM, RowdyBurns said:

Fitted an aftermarket turbo oil supply line?

That's going to be a nice setup when it all comes together, throw a pic up of your ute.

Ye cheers mate. Im looking forward to it. The gear has been sitting in the garage for 2 weeks.

I will get it installed the day before the tune.

il post some photos up tommoz.

  • Member
  • Member For: 15y 1m
  • Gender: Male
  • Location: Rhodes, Sydney.
  On 09/08/2011 at 10:48 AM, Dillz said:

I'd budget for an engine rebuild if the weak BA bottom end lets goes with the new power.

Dillz, that what I'm worried about mate. They say anywhere around 360 rwkw

Can b dangerous. That's why I kinda wanted a ball park figure

Of how muck rwkw I will b looking at... I'm not sure where I would stand?

  • Three pedals are better then two..
  • Donating Members
  • Member For: 17y 10m 26d
  • Gender: Male
  • Location: Melbourne

Yeah that sounds about right, ya never know it might last but better to be prepared for the worst. Alot depends on the tune too.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'