Jump to content

Roll Or Pump?


Brods

Recommended Posts

  • Three pedals are better then two..
  • Donating Members
  • Member For: 17y 9m 5d
  • Gender: Male
  • Location: Melbourne

You could grind it but if you get too close to the front it will chip, not to mention the sharp edges and rust? There is heaps of room on the utes, surely the right offset would support 295's?

Link to comment
Share on other sites

  • Member
  • Member For: 14y 11m 25d
  • Gender: Male
  • Location: perth
  On 30/01/2012 at 7:22 AM, STAINOnegger said:

low down just told me he cant roll ute rears because it will crease :-/

the pics I put up are with rolled and pumped guards, easy to do urself

Link to comment
Share on other sites

  • You've changed man....
  • Donating Members
  • Member For: 14y 2m 4d
  • Gender: Male
  • Location: 2 Fuchsia Court, Narre Warren. 3805

yer, give us ya knowledge :P

im a sheetmetal worker by trade, doubt id have a problem, just dont have a tub at the moment I can eyeball over

Link to comment
Share on other sites

  • 3 months later...
  • You've changed man....
  • Donating Members
  • Member For: 14y 2m 4d
  • Gender: Male
  • Location: 2 Fuchsia Court, Narre Warren. 3805

Stretched tyres not for me. Prefer to go an inch narrower so the wall isnt stretched at 45 degrees.

Not sayin its sh*t, heaps of people like that look. Just im not one of them.

  • Like 1
Link to comment
Share on other sites

  • Tampon inserted, Auto Acquired, next purchase a new handbag
  • Donating Members
  • Member For: 16y 11m 11d
  • Gender: Male
  • Location: Vic

That's awesome. Bit narrow on the rear though. What are sizes?

Jases wussed out and ordered +40s FFS.

Edited by Henz
  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'