Amplifier Connection

[Super Nes]

Hi guys,

I have a Pioneer GM-D9500F. It's a 4 channel amp, with the ability to switch to a 2 channel. All I want the amp to power is 1x 12" Sub.

In the second image, how are my connections to be made? Do I bridge anything out?

Power, ground and system control are fine.. it's more to do with just the Sub Connection.

Ta

[Super Nes]

From the amplifier manual if this helps.

[1600dave]

Flick the switch to 2 channel.

Make sure your sub impedance is no less than 4ohm or you'll overload the amp.

Connect the sub like in two channel output (mono)

You wont need to connect a second speaker as per the pic, effectively that channel is just not being used.

[Super Nes]

Flick the switch to 2 channel.

Make sure your sub impedance is no less than 4ohm or you'll overload the amp.

Connect the sub like in two channel output (mono)

You wont need to connect a second speaker as per the pic, effectively that channel is just not being used.

Impedance is 4 ohms

Thanks mate

[Super Nes]

in case anyone checks this later, it's all done