Jump to content

336Rwkw & 1158Nm Built @ Adicted


MADTXI

Recommended Posts

  • Donating Members
  • Member For: 13y 6m 25d

what rods are in it?

Not shore on make but not stock used ones from old motor

Going to get full parts list by end of week just waiting on the boys at adicted to write it all up.(old motor had a lot of good gear in it as well)

Link to comment
Share on other sites

  • Here since the start...
  • Lifetime Members
  • Member For: 21y 9m 29d
  • Gender: Male
  • Location: Victoria

Ant, you've got nothing to prove mate. Don't worry about it.

There was only one person doubting you and he hasn't replied since most people supported you.

Link to comment
Share on other sites

  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 17y 2m 30d
  • Gender: Male
  • Location: Probably above atmospheric pressure

With luck you'll line up an HSV when you run it at Calder :turboboink:

(worry if he has an intercooler too though :buttrock: )

Link to comment
Share on other sites

  • Tampon inserted, Auto Acquired, next purchase a new handbag
  • Donating Members
  • Member For: 16y 11m 4d
  • Gender: Male
  • Location: Vic

Don't worry bout it Ant, where all sure the powers there. As for torque,'we all know unless it's an engine dyno it's never 100% accurate either.

I agree you should get it out to calder though, it's a heap of fun and good to have the time slip to go with it.

Link to comment
Share on other sites

  • Tampon inserted, Auto Acquired, next purchase a new handbag
  • Donating Members
  • Member For: 16y 11m 4d
  • Gender: Male
  • Location: Vic

Tonyv's car made 450rwkw onthe same dyno.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'