Control Blade Bush

[bjcrown]

Guys,

I'm looking into replacing the Control Blade bushes with SuperPros (see pic). Have been advised that the old bushes are difficult to remove.

What is the best way to removed the old ones and replace them?

Any tips would be very much appreciated.

Thanks...

[ChrisConfal]

I pressed mine out to fit nolathane ones in, had to cut the old ones out of the arm as a 20t press wsnt strong enough, then pressed the new ones in without to many problems, just have to watch te arm as you press it so it doesnt bend/flex much as there isnt alot of support to use while prssing

Sent from my OMNIA7 using Board Express

[Guest XR09]

Best way is to take it down to your local pedders or suspension place. It needs a fairly good press.

[ChrisConfal]

Pedders quoted me about 150 from memory, woud be the no fuss way if you arent confident ding it yourself

Sent from my OMNIA7 using Board Express

[djextreme]

Has anyone tried the pedders control blade bushes?????

[djextreme]

Or should I just get them to use the super pro ones???

Also what's ppls opions on changing all three of the diff bushes to super pro comfort bushes?? Will this create more noise? Or should the smaller ones b replaced wth standard bushes? N center a super pro??

[Ralph Wiggum]

Go superpro, do all 5 bushes. get them installed properly and the increase in noise will be minimal