Jump to content

Recommended Posts

  • ...JD TUNING ADELAIDE...
  • Gold Donating Members
  • Member For: 16y 11m 13d
  • Gender: Male
  • Location: Adelaide

well sunday hopefully it backs up a good time and mph and that's all I need :turboboink:

I think a MASSIVE THANKS TO BRUCE HEINRICH for hes excellent tuning abilities and the small blonde one who works with him :roflmbo:

Edited by JETSNOT
  • UNDERCOAT CRUISER!!!
  • Donating Members
  • Member For: 16y 3m 27d
  • Gender: Male
  • Location: brisbane

any special reason the dyno run was done in shoot 8f?

good power for the mods done! well done. :icon_ford:

Edited by fpv6t
  • ...JD TUNING ADELAIDE...
  • Gold Donating Members
  • Member For: 16y 11m 13d
  • Gender: Male
  • Location: Adelaide

bruce always uses it theres some reason but aparently means fark all to me someone in the no can answer :dontknow:

  • Donating Members
  • Member For: 17y 10m 19d
  • Gender: Male
  • Location: south east suburbs

I dare say that paper ford air filter makes all the difference :-) just take it easy on the 1st take off and go from there. Good luck for Sunday enjoy....I might see you there in my 317++++++++++++++++ rwkw ute.

  • Like 1
  • Banned
  • Member For: 15y 9m 27d
  • Gender: Male
  • Location: Aspendale, Vic.

haha its on!

but I wont be down this week as I have my engagement ;( .. maybe I can reschedual it.... (lol).

GL! Shanon went 10.4 with his fg on 450rwkw or so so you should sneak in the 10's! with a 1.6!

  • Bob the Freaking Builder
  • Donating Members
  • Member For: 15y 8m 1d
  • Gender: Female
  • Location: SA

Well, since I weigh less than him I'm hoping for a better time in the snot box, GONNA BE THE FASTEST FLUFFY IN A TURBS IN SA weeeeeeeeeeeeeeee :roflmbo:

  • Like 1
  • Donating Members
  • Member For: 16y 2m 12d
  • Gender: Male
  • Location: Vic

Wow,how the hell you getting 421rwkw with a stock FG F6 cooler, stock exhaust and hi-flow cat. Basically the same setup as me but im about 120rwkw short, doesnt add up

Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'