Big Dazza Member 33 Member For: 15y 11m Posted 13/12/10 12:59 PM Share Posted 13/12/10 12:59 PM (edited) Finally got round to giving my new toy a wash and polish (after 2 weeks).I noticed that the panel fit where the rear bumper meets the quarter panel is poor ie the panels are not flush at the joint with the quarter panel sitting approx 1 to 2.5mm proud of the bumper along the line of the joint. It is consistent on both sides of the car. It is annoying me now that I have noticed it. Is this normal build quality, or has my new toy possibly had a minor shunt at some stage? Was purchased as a low km demo. If this isn't normal I will report it at the 3000k service.Feedback appreciated.Cheers Edited 13/12/10 01:03 PM by Big Dazza Link to comment https://www.fordxr6turbo.com/forum/topic/72160-poor-panel-fit/ Share on other sites More sharing options...
Roof Member 213 Member For: 16y 8m 20d Gender: Male Location: Perth | Busselton Posted 13/12/10 03:45 PM Share Posted 13/12/10 03:45 PM I read somewhere (may of been on these forums) before I ordered my car that people had problems with that same join with paint peeling off on early FG's.. I'll check mine out tomorrow, post a pic up for us to see Link to comment https://www.fordxr6turbo.com/forum/topic/72160-poor-panel-fit/#findComment-1063448 Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now