beast_man88 Member 7 Member For: 14y 4m Gender: Male Posted 24/09/10 04:35 AM Share Posted 24/09/10 04:35 AM Hi All. First time posting. rather desperate for info. I have just finished converting to manual and am wondering if anyone knows where I can wire my reverse switch on the gearbox to??? I have kept the auto loom and just fitted a manual pcm. also I am having troubles with my cruise not working now. I have wired the clutch pedal switch up, do you think maybe the pcm I have doesnt have cruise enabled?Thanks in advance for any advice/info Link to comment Share on other sites More sharing options...
beast_man88 Member 7 Member For: 14y 4m Gender: Male Posted 29/09/10 12:01 AM Author Share Posted 29/09/10 12:01 AM No one?? Link to comment Share on other sites More sharing options...
Ralph Wiggum Moar Powar Babeh Lifetime Members 19,323 Member For: 19y 3m 29d Gender: Male Location: Perth Posted 29/09/10 12:34 AM Share Posted 29/09/10 12:34 AM If you haven't already, buy a BA manual from Ebay, find the correct wire colours for the reverse switch wires. Extend these, Feed them over the box to the switch on the RH of the box. Crimp two insulated spades on the wires and connect.You didn't need to change the pcm, only need to flash a manual config file into it. Im assuming your auto trans harness is still in place. if not you will need to find the correct pin outs from the pcm for the reverse light wiring and extend down to the gear box. Link to comment Share on other sites More sharing options...
beast_man88 Member 7 Member For: 14y 4m Gender: Male Posted 30/09/10 06:33 AM Author Share Posted 30/09/10 06:33 AM If you haven't already, buy a BA manual from Ebay, find the correct wire colours for the reverse switch wires. Extend these, Feed them over the box to the switch on the RH of the box. Crimp two insulated spades on the wires and connect.You didn't need to change the pcm, only need to flash a manual config file into it. Im assuming your auto trans harness is still in place. if not you will need to find the correct pin outs from the pcm for the reverse light wiring and extend down to the gear box.I have a workshop manual but it doesnt say anything about wire colours just pin numbers, it says pin B30 so I tried that and no good. I have still got the auto selector switch plugged in and zip tied under the car with it in park position. if I remove it the car will not crank. shouldnt I be able to run without this with the manual pcm. will a manual ba start with the clutch not pushed in. maybe my clutch switch is not wired correctly. Link to comment Share on other sites More sharing options...
Guest newl Guests Posted 30/09/10 06:38 AM Share Posted 30/09/10 06:38 AM Yes. My BA F6 will start with the transmission in neutral and the clutch not depressed. Link to comment Share on other sites More sharing options...
beast_man88 Member 7 Member For: 14y 4m Gender: Male Posted 30/09/10 07:38 AM Author Share Posted 30/09/10 07:38 AM well then it cant be the clutch switch. unless my BEM is causing the car not to start as it knows its not in park, I may have to just leave to gear position switch connected and zip tied up under the car and just run a 12v to the gearbox reverse switch then to the tow harness in the boot. this will work but didnt want to do it dodge. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now