Jump to content

Post Your Street Tyred 1/4 Mile Time!


tonyv

Recommended Posts

  • Donating Members
  • Member For: 14y 3m 10d

Ran at WISD tonight.. 11.902 @ 118.789 with 1.89 60ft.

285 x 20Invos(260 wear). Couldnt stall it more than 2000rpm or it just went up in smoke.

Niz cooler, 1000,s and 4/5inch cat/dump.. standard exhaust.

  • Like 1
Link to comment
Share on other sites

  • RNS10S
  • Donating Members
  • Member For: 18y 3m 13d
  • Gender: Male

Ran at WISD tonight.. 11.902 @ 118.789 with 1.89 60ft.

285 x 20Invos(260 wear). Couldnt stall it more than 2000rpm or it just went up in smoke.

Niz cooler, 1000,s and 4/5inch cat/dump.. standard exhaust.

Track has been very slippery the last couple of weeks, I think it gets cold very quickly and by the time you race there is no heat in the track, good job Jimmy

Link to comment
Share on other sites

  • Donating Members
  • Member For: 14y 3m 10d

Thanks guys..

Pretty chuffed cracking an 11 1st time out. Still a bit of touch up on the tune to do. Early days. :)

As average as the track was last night..competitor numbers were way down.. so managed to get 7 runs..and more if I wanted. So it was easy to stay in the groove and get a handle on what the car was doing..

Ran 4x 11.9's,... the other 3 I buggered up. Atleast you can say Im consistant !!

Link to comment
Share on other sites

  • Donating Members
  • Member For: 14y 3m 10d

Hey Pete..

Yeah not bad.. I still think thers a tenth or two in it. I put some serious heat into them.. 2nd gear burnout.

On the night 2000rpm was about the limit between a decent lauch and wheel spin.

Dont get me wrong.. when they hooked up you could feel them bite hard.. But you have to get the warm.

Im also thinking of going back to my 19inch Simmons next time out..

Link to comment
Share on other sites

  • Waiting for the 1st N/A 12!
  • Donating Members
  • Member For: 16y 9m 18d
  • Gender: Male
  • Location: Sydney

If that's what you drive on the street with then it counts in my book

hmm time to throw some 305's on and have another go!

Nah I thought it was the stock width the car came out with I.e. 245's! JP300 set the bar with his 11.15 on 245's and hence I thought that's what it had to be broken on!

Anyways good effort anyways mate nice job!

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'