Jump to content

Recommended Posts

  • Member
  • Member For: 15y 9m 20d
  • Gender: Male
  • Location: Melb.

I'm looking at putting a X-Force 4" Dump pipe with high Cat on my BF F6.(Auto)

Anyone tried these and are there any issues with fittment (not fitting correctly,knocking etc..) or engine light coming on?

I will be getting a custom tune soon after fitting.

It seem there are a few problems with high flow cats causing engine lights to come on

even after a custom tune ?

Any help would be appreciated.

Cheers Peter.

0418 338 005

Link to comment
https://www.fordxr6turbo.com/forum/topic/64319-x-force-4-dump-high-flow-cat/
Share on other sites

  • Member
  • Member For: 16y 9m 6d
  • Gender: Male
  • Location: North West Aus

Will be interested in what people say. My next upgrade on my BF F6 will be upgrading the stock exhaust and cat, since my car will be clearly running over 300rwkw's after tuesday next week.

  • Donating Members
  • Member For: 17y 7m 7d
  • Gender: Male
  • Location: Perth

I had the engine light come on after fitting a high flow cat when I ran the stock dump pipe. As exhaust gas/flow etc did not correspond with factory parameters. It was sorted by my tuner and I expect yours would so the same.

I am currently running a Xforce 4" dump into Xforce high flow cat and intermediary piece back into stock centre/rear muffler and the dump did slightly touch some of the heat shielding around the steering which was a real annoyance with intermitant vibration/noise. I have since had a small section of the shielding removed which doesnt seem to have affected anything and the noise is gone, so its all good.

  • 2 weeks later...
  • New Member
  • Member For: 15y 4m 26d
  • Gender: Male
  • Location: perth
  On 18/12/2009 at 6:43 AM, kb351 said:

I had the engine light come on after fitting a high flow cat when I ran the stock dump pipe. As exhaust gas/flow etc did not correspond with factory parameters. It was sorted by my tuner and I expect yours would so the same.

I am currently running a Xforce 4" dump into Xforce high flow cat and intermediary piece back into stock centre/rear muffler and the dump did slightly touch some of the heat shielding around the steering which was a real annoyance with intermitant vibration/noise. I have since had a small section of the shielding removed which doesnt seem to have affected anything and the noise is gone, so its all good.

Hi mate what does it sound like and any power gain with xforce set up?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'