Best Way To Evenly Apply Badges

[berzerker]

Have bought new turbo badges, but being individual letters am worried about putting them on unevenly.

Does anyone have an trick to doing it so that everything lines up nicely?

[XtRmn8]

The letters should be stuck on to face tape so you do not need to separate the letters.

[Chich]

if for some reason they aren't (which I doubt) lay them out on some masking tape first and then apply them all at once.

[berzerker]

Nah they are.. but do u mean sort of fold the backing plastic half way down and stick on then peel the remaining plastic off that way? I did think of that, but seems dodgy.

Thought somebody might have a better way

[XtRmn8]

There is only one way to put these badges on. When I bought my ute is did not have any badged on it and I put them all back on and all badges have the semi clear face tape on them.

My car is white so it was easy to measure and mark with a pencil then peel the backing tape and line the bottom of the badge with a base line a marked and stick it to the car. Rub the badge with a cloth applying even pressure si it stick to the car. Then peel the face tape off and you are done.

If someone sold you a Turbo badge with individual letters I'd send it back to em.

[berzerker]

Thanks mate, that's what I was after!

They are individual letters cause its a G6E Turbo badge (I will be only putting on 'TURBO 6"

[Pete A]

I made a simple template with cardboard and then positioned it under the XR6 badges on the doors. Worked a treat. Individual letters would be a pain but once again if you create a template with double sided tape would work.

[berzerker]

Thanks mate, already got them on. Had a *beep* of a time getting them on. Had to it individually in the end.

[berzerker]

meh

Edited 19/10/09 10:28 AM by berzerker