Jump to content

Recommended Posts

  • Member
  • Member For: 16y 3m 12d
  • Location: adelaide

getting my bf tuned by bruce at heinrich next month, ive bassiclly brought/fitted alll the gear then getting him to tune it, my goal is 300kw heres what ive got, if ive missed anything/need anything please let me know

hdi intercooler kit

flash box 1

deka 60s

walbro gss342

cat

twin 2.5 system

typhoon snorker/kandn filter

I dont have an acuator though do you think ill need one for my goal?

Link to comment
https://www.fordxr6turbo.com/forum/topic/59863-getting-my-car-tuned/
Share on other sites

  • Member
  • Member For: 16y 3m 12d
  • Location: adelaide

ahh thank you typhoon freak, I plan to get news ones pre gapped at .8 as its due for new plugs anyways at it nxt service which isnt too far away

Edited by jasol
  • Banned
  • Member For: 15y 10m 29d
  • Gender: Male
  • Location: Blacktown NSW

How did you go with the pump install? The pick up on the GSS342 is not offset like the 341 and the filter is a real b@#$rd to get on. If you can get the 341 it will make life much easier. Was yours hard to do?

Also with the HDI install you lose your top snorkel. Make sure you re route the cold air using a duct or use a larger intake than the F6 behind the snorkel because the opening on the F6 snorkel on its own may not flow enough. If you can avoid it, don't remove the top snorkel and leave the air box volnerable to hot air from the engine and rad fans.

If you look at your mods they are similar to mine so I think you should be on the money with about 300rkw.

  • Member
  • Member For: 16y 3m 12d
  • Location: adelaide

I havent got around to doing the pump yet if I can use a mates hoist ill do it but if not ill just get bruce to do it as there pritty hard in the utes even worse without a hoist, im just going to run a 90 degree bend faceing the ground were the snorkel went that way it shouldnt suck to much hot air,

when I had my capa 10psi tune loaded it boosted to 14 but I didnt get it up in the revs as I wasnt happy with it doing 4psi more damm generics would have been really pissed off if I had of brought it to use the generics not intending on getting it dyno tuned

  • Banned
  • Member For: 15y 10m 29d
  • Gender: Male
  • Location: Blacktown NSW

Mate, believe me if you can swap the 342 for a 340 or 341 before the install you will save yourself a lot of mucking around trying to fit it into the factory swirl pot.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'