Jump to content

Steering N Brakes


hafadude

Recommended Posts

  • Donating Members
  • Member For: 19y 7m 21d
  • Gender: Male
  • Location: Cairns Qld

Had a few little probs for a while.

One, the usual brake shudder when braking and that's common with Falcons and second, the handbrake needed adjusting. Decided to get them looked at. Well the brake shudder is gone after having the rotors machined and the handbrake is fine now. But now I have two other problems that weren't there before the service.

The brakes squeak like crazy after they get warm and the squeak is there even if I'm not using the brakes. Second, the occasional vibration through the steering when moving at slow speeds like parking (again common prob with T's I hear), is there almost all the time now when turning a corner or doing a U-turn. The workshop said the only thing that they did apart from machining the discs and adjusting the handbrake was that they put my almost new tyres from the back to the front cos the fronts were worn a bit. They said the power steering needs a rebuild kit.

Any clues on these? :stupid:

Link to comment
Share on other sites

  • Sucker
  • Moderating Team
  • Member For: 20y 8m 9d
  • Gender: Male
  • Location: Brisbane

Sounds like air in the power steering...caused by turning the steering without the engine running.

Try finding an empty car-park and doing figure eights for a couple of minutes; I think that's still Ford's standard fix for it believe it or not!

Is the squeaking brakes just coming from the rear? As in just the park brakes rubbing?

Link to comment
Share on other sites

  • Donating Members
  • Member For: 19y 7m 21d
  • Gender: Male
  • Location: Cairns Qld

Hey, thanks tab. I'll try the car park thing. Sounds like a fun way to fix a problem. The cost is good too.

Yeah, I think the squealing of the brakes is from the rear as far as I can tell. Maybe its that the parking brake was overtightened?

Link to comment
Share on other sites

  • My engine bay is Bionic
  • Donating Members
  • Member For: 18y 9m 15d
  • Gender: Male
  • Location: Freeways
Had a few little probs for a while.

One, the usual brake shudder when braking and that's common with Falcons and second, the handbrake needed adjusting. Decided to get them looked at. Well the brake shudder is gone after having the rotors machined and the handbrake is fine now. But now I have two other problems that weren't there before the service.

The brakes squeak like crazy after they get warm and the squeak is there even if I'm not using the brakes. Second, the occasional vibration through the steering when moving at slow speeds like parking (again common prob with T's I hear), is there almost all the time now when turning a corner or doing a U-turn. The workshop said the only thing that they did apart from machining the discs and adjusting the handbrake was that they put my almost new tyres from the back to the front cos the fronts were worn a bit. They said the power steering needs a rebuild kit.

Any clues on these? :headbang2:

Change your rotors, DBA 4000 slotted is the most common upgrade and then avoid the never ending shuffer issue. Especially if your a BA! Just do the front if your tight. Squeaking/squealing brakes is common when upgraded but if they are doing there job then its not a problem unless your pads are worn out.

I.B.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'