Jump to content

A Stock Internal Ba Xr6t Motor Can Run A Nine


blueboost

Recommended Posts

  • Replies 160
  • Created
  • Last Reply

Top Posters In This Topic

  • Member
  • Member For: 16y 8m 11d
  • Gender: Not Telling

Aweome effort on all the times there Dave, and it sounds like yours was on track for a PB before she blew :crybaby:

Do you have any vids of the run? Or pics of the engine carnage?

That 10 second BF F6 is one of only a few too, congrats, any details on mods/power/boost etc?

:beerchug:

Link to comment
Share on other sites

  • Member
  • Member For: 20y 9m 12d
  • Gender: Male
  • Location: Mackay NorthQueensland
Aweome effort on all the times there Dave, and it sounds like yours was on track for a PB before she blew :pinch:

Do you have any vids of the run? Or pics of the engine carnage?

That 10 second BF F6 is one of only a few too, congrats, any details on mods/power/boost etc?

:laughing:

I think the 10.51 was the quickest from memory, the 10.4 had tolulene as a octane boost in it, although it was dynoed on 98, but it did have toly in when it raced.

I have a video, and a bag full of bits they got off the track, I will see if I can download it. I don't think they minded cleaning the strip up, the car has given them a lot of good runs and has brought them a lot of cars to.

the F6 has all his mods in his own topic, but there just the normal stock turbo with actuator, process west gear, xfoce exhaust.(Grizly)

David

Edited by blueboost
Link to comment
Share on other sites

  • Member
  • Member For: 20y 9m 12d
  • Gender: Male
  • Location: Mackay NorthQueensland
Watching it off the line looked like you got a fair bit of wheel spin, however it was out da there.

Yeh had to much presure in the rear tyres for the temp, so it would have increased to much after the burnout, to get it running consistent 1.3 60fters, I am going to have to monitor things a lot more closely, might have to start writing it all down so I adjust more presicely,

also might be time to move away from the stock suspenion, and put 90/10's in the front. I left the line at 8.5 psi that time, but she only done a 1.44 60ft, a bit more grip, and she will do better then that. I adjusted up the hand brake during the week, and it worked a treat, did not move untill I let it go. might have to ring 6Boost about his cromolly tail shafts, before it gives up to.

well done to you and your Kenny Bell xrmate got your car on video and Nathens F6's ten sec runs, you always do a good burnout.

my burnout was a bit slack I no, but I knew I was at the end of what that motor was going to cope with so I was looking after it.

David

Edited by blueboost
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'