New Mods N Tune On Vcm Suite

[Butto]

Hey all,

Dropped my car off to Mark @ MRC Performance n Dyno Services at 7am wednesday morning for a bit of work. Got a call about 9am saying the new 4" dump through to 3.5" cat have been fitted n they were about to start on my bosch 968's then put it on the dyno to start tuning it.

Got another call from Mark at about 1:30 that afternoon saying on its first run it pulled 287rwkw but is starting to misfire cause the plugs arent to the job....

End result: 296rwkw @ 12-15psi and a huge smile on my face n brown spot in my grundies (was raining when I got it back)

Huge thanks to Mark n all the guys at MRC for the work they did n keeping it on the dyno for about 4 hours when u were having problems with the boost control

Full list of mods:

-PW stage 2 IC, crossover replacement n CAI

-Xforce 4" Dump through to 3.5" Cat

-Bosch 968 Injectors

-Centre Muffler Remover

-VCM Custom Tune

Thought I may as post this, one of the few people who decided to take a different path n give VCM suite a go n its returned a great result.

Cheers

Butto

[mr gsr]

I had Dale tune my BF last week using VCM.... We achieved 318.9rwkw on 15psi, however, heatsoak was causing up to 4deg of timing to be pulled....

Mods are:

BFII xr6t ZF

Process West Stage 1 Cooler

Process West Hot Side Intercooler Piping

Process West UBP

F6 CAI

Process West Surge tank and Bosch 044

Siemens 60lb injectors

Garrett ported exhaust housing with actuator

Tunehouse exhaust

Decided to go to stage 2 now, fitting up the Process West Street Plenum kit and race intake tomorrow.. Then back to the dyno

[Adam]

Nice results!

Is VCM still in Beta or is there a full release? I might get mine tuned with it when/if they ever enable ZF tuning.

[envyxr]

Hi boys I 2 have had a VCM tune and mods done recently and couldnt be happier. I ended up with 306.7 rwkw and 882.1 n/m of torque .I will need a retune as soon as I put in a new clutch as it is slipping ,so I should get a bit more out of it. My mods are as follows:X-Force 4" dump and 3.5" system,10.5 lb actuator,60lb siemens injectors,nizpro valve springs,walbro in tank fuel pump and an fpv stock intercooler ,not big enough I know but its twice as big as the stock xr6 one that it had.