Jump to content

Xforce Exhaust Thread


THEMESHMAN260

Recommended Posts

Stock FPV coolers are fine for ~300rwkw but they aren't efficient at those power/boost levels. They suffer pretty bad from heat soak at stock boost levels, and it's just amplified as power/boost increases.

To have consistent power run after run, a good flowing cooler is needed :ph34r:

Link to comment
Share on other sites

  • 2 weeks later...
  • Member
  • Member For: 16y 11m 8d

I know this is a Ford forum but I need a little help.

A mate of mine bought an Xforce exhaust to suite his S14 but it's missing a couple of gaskets and a few bolts.

Do you guys know of anywhere I could get some gaskets from?

I've tried Xforce but have had no response.

Thanks

Joel

Link to comment
Share on other sites

  • Forged Member
  • Lifetime Members
  • Member For: 17y 9m 11d
  • Gender: Male
  • Location: SW Sydney

Any exhaust shop would be able to help him out mate, alternatively if its a generic style gasket you could go to Supercrap - pretty sure they could get something for you.

You could get bolts from bunnings too, they generally have all types and sizes

Link to comment
Share on other sites

  • Member
  • Member For: 16y 11m 8d
Any exhaust shop would be able to help him out mate, alternatively if its a generic style gasket you could go to Supercrap - pretty sure they could get something for you.

You could get bolts from bunnings too, they generally have all types and sizes

First to answer again mate, thanks.

Was thinking that may be my only alternative. It looks pretty simple. It's a single 3in.

Link to comment
Share on other sites

Senna's on the money :nod:

I'd give Xforce a chance to get back to you though mate. Why pay when you should of been supplied with the gear in the first place? Had similar drama's recently with my Nizpro kit...

Link to comment
Share on other sites

  • Member
  • Member For: 16y 11m 8d
Senna's on the money :nod:

I'd give Xforce a chance to get back to you though mate. Why pay when you should of been supplied with the gear in the first place? Had similar drama's recently with my Nizpro kit...

The exhaust is second hand( $300 from turbo back in stainless steel), it's not Xforces fault these parts are missing, my mate just didn't recieve them from the guy he bought it of.

Link to comment
Share on other sites

  • 2 weeks later...
Guest EGOXRT
  • Guests

Desperately need some pics of an unfitted xforce large body twin 2.5in centre muffler.

I need to be able to see the angle of the rear flange with the muffler sitting on the ground please.

Need to know if it sits the same as the one below..

198400977_o.jpg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'