Hid Kit Install

[PHANTMXR6]

If they are flashing then they must be moving. Either the globes in the holes, or the whole reflector.

I set mine up in the shed.

With the original globes fitted parked the car back approx 3m from a wall and marked the wall where the top of the solid light beam was. I did the same with the HID's but set the solid line slightly lower. Tthere was a bit of mucking around, but I found a happy medium in the end.

[davorulz]

I bought one of these sets off forum, an straight away they would be in an out(as in turn on an off). after a week the drivers side light wouldn work. to this day completly off no light on right hand side an then some times the other one will turn off an I have no light at all!

[PHANTMXR6]

Have you checked all your connections?

Sounds like a dodgy earth.

[davorulz]

there was no earth wire? the ones on the forum where bassicly a straight swap over?

[senna_T]

Have you spoken to the person you got them off for change over pair just in case you got a faulty set?

[davorulz]

tryed to get into contact with NYT-SKY who I got them off, but he wont reply any ideas anyone?

[smicky]

HID - in a B series...

True or False?

This is not legal in NSW - unless factory, and/or self leveling?

I ask as I do not know, however have heard that it may not be legal...

Or is it that ADR approval is on 4300 and 6000, but nothing else?

Then if ADR ok, is it also then state approved or depends on the state?

Edited 30/05/10 02:13 PM by smicky

[Ralph Wiggum]

HID's aren't ADR compliant in any vehicle that does not have self levelling/cleaner headlamp assemblies.

Bascially if they where nto factory fitted the aren't legal. I dont think any vehicle sold by for in Aus has self levelling/cleaning lights??

[smicky]

HUH?

So... are they or are they NOT allowed on a BF?

BF - Not factory HID, Not self leveling, Not cleaning.

?????

[senna_T]

Not legal....