Jump to content

What Fuel Pump And Injectors?


Recommended Posts

  • Azzman
  • Member
  • Member For: 16y 6m 8d
  • Gender: Male
  • Location: Melbourne

G'day guys. I'm building a turbo motor with forged internals, once I get this going I will be running it with an F6 fuel pump and F6 Injectors on standard boost to run the motor in. Once I'm happy with this set up I will be going nuts with the boost and other mods, hopefully making around 300-350+RWKW. Which fuel pump and injectors would you guys reccomend to use to accomodate this sort of power?? Its a BF MKII Ute so should I invest in some sort of surge tank or something as well to stop any lean outs that may occur? Any help is appreciated guys! Cheers.

Link to comment
Share on other sites

  • Replies 23
  • Created
  • Last Reply

Top Posters In This Topic

  • Forged Member
  • Lifetime Members
  • Member For: 17y 11m 24d
  • Gender: Male
  • Location: SW Sydney

Either the Bosch 968's or the Siemens Dekas will do the job, but the dekas are going to have more scope if you want to push closer to 400 - and with a forged bottom end why wouldn't you?

You could look at the Process West surge tank, or alternatively search for hanra's thread about how he did one himself on his ute.

Link to comment
Share on other sites

  • Forged Member
  • Lifetime Members
  • Member For: 17y 11m 24d
  • Gender: Male
  • Location: SW Sydney

No they are too big to run on the standard tune, if you have the stock injectors, just use them until you are ready to get a tune. Alternatively you could get a "run in" tune that is scaled to the dekas

Link to comment
Share on other sites

  • Azzman
  • Member
  • Member For: 16y 6m 8d
  • Gender: Male
  • Location: Melbourne

ok then I have typhoon injectors so I'll run them to begin with then swap to the dekas for a more agressive tune. Will a surge tank be neccessary with the ute? I've read that the utes arent to bad with the surging problems.

Link to comment
Share on other sites

  • Forged Member
  • Lifetime Members
  • Member For: 17y 11m 24d
  • Gender: Male
  • Location: SW Sydney

They aren't quite as neccesary in the utes, but they are a good safety barrier just incase you get a bit carried away with a quarter of a tank.

Link to comment
Share on other sites

  • Azzman
  • Member
  • Member For: 16y 6m 8d
  • Gender: Male
  • Location: Melbourne

cool. So where would you guys recommend to get the dekas and surge setup from? do any forum advertisers give good deals on these parts? or will I have to look around?

Link to comment
Share on other sites

  • Forged Member
  • Lifetime Members
  • Member For: 17y 11m 24d
  • Gender: Male
  • Location: SW Sydney

Shop around a bit mate, the dekas can be had on Ebay, a site advertiser RAP1D sells them and so does just about all the workshops. The surge tanks can be had From Process west or again most workshops can sort something out.

Link to comment
Share on other sites

  • Member
  • Member For: 21y 11m 22d
  • Gender: Male
  • Location: byron bay more underarm hair per square km

im looking at injectors at the moment and have been told that the dekas can cause rough idle is this correct ?I hope not cause the dekas are a damn site cheaper than the 968s

Edited by simmo
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'