Monza Bov

[reconize3]

hi, I'm new to this and don't reeli quiet know how 2 use it, ok well I have a ba xr6 turbo ute and just bought a new monza double seq bov and don't reeli know where it fits, I need to weld it to a pipe but not sure where, can anyone help ????

ryan

[sensoryamusia]

you shouldn't have to weld it anywhere man,

I'm pretty sure the monza ones come with 3 different adaptors?

remove the stock BOV from the top of the crossover, block it off and attach the monza to the lower inlet on the crossover.

and

Edited 07/08/08 10:37 AM by sensoryamusia

[antigravity]

If its anything like the Monza BOV I got, it didn't come with any adapters... Just an inlet with small allan screws around the edge which you're supposed to tighten and then weld the BOV on.

You don't need to do that though...

I removed the stock blowoff valve completely. Blocked up the inlet at the back/rear of the crossover with a chair plug, got a longer 1" hose, ran it from the front inlet on the crossover (near the throttle body), which runs down near the airbox. I then clamped the BOV to the end of the hose. Done. Works a treat. The BOV is too big to be in the stock location.

Only reason I changed it was that my stock BOV seemed to leak boost at low RPMs. Really couldn't care less what BOV I got as long as it stopped the boost leak. Which it did, and it sounds great too. Has a nice flutter to it.

Edited 07/08/08 10:03 PM by antigravity