How Do I Wire The Surge Tank

[SILK RSPEC]

Guy's I am intsalling all the stuff on my car and need to fit the procees west surge tank tommorrow, where is everyone getting the power from to run the pump and do I need to find the fuel pump signal wire and run a relay or something? Has anyone got some how to wiring diagrams and photos which would help? I am not to bright when it comes to car wiring, know some basics and can solder that's about it

[ETM]

you have to remove the fusebox inner part,lift it out as best you can.

locate the fuel pump relay, it will have 2 bigger wires, and 2 smaller ones, of the 2 smaller ones one is the earth and the other is the 12v signal wire. I cant remember the coulur but a simple test with a test light will show you which one it is.

Trace that wire back as far as you can, you will only get about 2 inches max from memory, snip it off and splice another wire into the join and then solder it back to the other end of the wire, the original wire is now reconnected and you have the spliced wire to use as the signal wire for the new relay which you will install for the new pump.

Run a new wire (4mm) from the 12v post in the fuse box to use as the primary power supply of the new relay,the same 4mm wire runs out to the pump from the relay, the wire you spliced is the signal wire and the last wire is an earth. That is the relay end taken care of.

Run the power wire down to the pump, fit a short earth wire from the pump to the body of the surgetank and you should be in business.

[AzMahoony]

THE PINK WIRE

You'll need to run a new relay also, but Lee has it all covered with the above post

[SILK RSPEC]

Thanks guy's wiring up fuel pump tomorrow