Jump to content

Recommended Posts

  • Member
  • Member For: 22y 5m 2d
  • Location: Sydney

My front bar has dropped about a centimetre and has now collected a driveway :thumbsup: All it's done is scratched the bottom (nothing else)

My question is, how can I get it to sit where it's meant to. It's only dropped by the original centimetre, but you can notice the gap.

Has anyone removed their front bar, or tightened theirs up? Is this easy to do, and can I just tighten a few bolts?

Link to comment
https://www.fordxr6turbo.com/forum/topic/4751-front-spoiler/
Share on other sites

  • Lifetime Members
  • Member For: 22y 6m 24d
  • Gender: Male
  • Location: South Coast NSW

Unfortunately no bolts to tighten - it is held in place by push-in clips along the guard, about four each side. And a few Xmas trees at the front of the wheel arch. It is located across the top of the front (steel) bumper bar by two lugs only.

Damned if I know how you'll be able to "lift" it, but maybe your dealer can get a local body shop to do something for you - good luck!!

Link to comment
https://www.fordxr6turbo.com/forum/topic/4751-front-spoiler/#findComment-37783
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'