Adding Rca Pre-outs To Icc Guide Is Here

[quadie]

thanks for the prompt service!

Audio IC info:

Toshiba

TA8276HQ

5ugm77

M'aisa

DATASHEET\

and with this data , I have worked out a remote for amp control

so I will add this data as soon as I can test it out (im in the middle of doing it , but got to excited , so I posted it be4 im finished

Edited 01/07/08 04:45 PM by Dagabond

[MICKAJ]

So basically your saying the audio quality will be heaps better if I go RCA and not levels into my amp? and this is for the crappest bottom line ICC

I don't expect to understand why but if it actually has some benefit then I'll take the time to do this.

[hanra]

  quadie said:

thanks for the prompt service!

Audio IC info:

Toshiba

TA8276HQ

5ugm77

M'aisa

DATASHEET\

and with this data , I have worked out a remote for amp control

so I will add this data as soon as I can test it out (im in the middle of doing it , but got to excited , so I posted it be4 im finished

IC details greatly appreciated mate!!!!!!!!!!!!!!

[quadie]

  MICKAJ said:

So basically your saying the audio quality will be heaps better if I go RCA and not levels into my amp? and this is for the crappest bottom line ICC

I don't expect to understand why but if it actually has some benefit then I'll take the time to do this.

unless u have a lc6 or simiilar , the 10 bucks u spend on bits at DSE is well worth the effort

if u live newcastle or syd pm me and ill let u hear the difference!

[MICKAJ]

Good guide, printed it out and did it last night.

-Took 6 hours

-Little screws were hard to get out, needed pliers on my screwdriver to break the seal

-Needed another pair of hands

-Needed a magnifying glass

-Need a really really fine soldering iron, really

[hanra]

Couldnt help myself. Will mod the ICC at work in the morn:

[quadie]

hahaha

ENJOY:)

[hanra]

Hey mate have you tried using pin 4 (standby) of the audio output IC as the switched 12v feed to the amp?

[MICKAJ]

NOOOOO don't say that, I never wanna rip that crap apart again and this is a question I asked today!

[hanra]

Or pin 6 and 20 are Vcc. But im not sure if the IC runs on a 12v rail? If it is a 12v rail I would think that there would only be Vcc applied there when the ICC is turned on.