senna_T Forged Member Lifetime Members 15,818 Member For: 18y 1d Gender: Male Location: SW Sydney Posted 28/06/08 02:24 AM Share Posted 28/06/08 02:24 AM as loong as the tune is right and you have good valve springs you should be fine at ~400 damo, there are a few doing it now Link to comment Share on other sites More sharing options...
mic Donating Members 1,725 Member For: 17y 22d Gender: Male Posted 28/06/08 10:44 AM Share Posted 28/06/08 10:44 AM The reason I was asking is because I have the F6 bottom end all ready and think I have the bolt ons to go close to 400RWKW but I am not sure if I want to push it to much.When I build my engine I will put an atomic in. Theres no way I will put 2nd best and then have 2 do it again. Its a big job and if you dont do it yourself then you will pay someone else heaps 2 do it. The phoon engines are great though this is just my opinion. Link to comment Share on other sites More sharing options...
AzMahoony Hench, but no longer shredded or tanned. Member 3,343 Member For: 17y 10m 12d Gender: Male Location: Canning Vale, W.A Posted 03/07/08 03:10 AM Share Posted 03/07/08 03:10 AM The bottom end and clutch will go if you go over 350, plus you'll need to do the actuator and waste-gate on the turbo to achieve higher boost Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now