Jump to content

Bf Xr6t Exhaust Onto A Ba


MRAH33

Recommended Posts

  • Member
  • Member For: 17y 7m 21d
  • Gender: Male
  • Location: MElbourne

hey guys just wanted to ask a few questions in regards to fitting a BF XR6t ute exhaust onto a BA xr6 ute.

1. will it work?

2. will it need any modifications to make it work?

3. how much of a difference will it make?

thanks,

roger

Link to comment
Share on other sites

  • Forged Member
  • Lifetime Members
  • Member For: 17y 10m 21d
  • Gender: Male
  • Location: SW Sydney

They do fit in there, do you have the entire exhaust or just cat back? If its cat back I think you need to get a merge made up for where the turbo system is twin and the NA is single

Link to comment
Share on other sites

  • Forged Member
  • Lifetime Members
  • Member For: 17y 10m 21d
  • Gender: Male
  • Location: SW Sydney

wouldn't cost more than a couple of hundred fully installed I guess, just get on the phone and speak to some shops, its not a big job so it shouldnt take them too long

:spoton:

Link to comment
Share on other sites

  • Member
  • Member For: 18y 1d
wouldn't cost more than a couple of hundred fully installed I guess, just get on the phone and speak to some shops, its not a big job so it shouldnt take them too long

:spoton:

You should ask this in the NA section or on AFF, it has been done lots of times and sounds really good.

You will need to get a Y piece made up from the cat to the twin pipes, shouldn't cost more than $300 I would think. Put a 3" Magnaflow metalcat on it at the same time, probably another $350 supplied and fitted but will be so worth it as the standard Ford cat is crap.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'