Jump to content

Wanna Be Able To Launch A Manual Like This?


groper

Recommended Posts

  • Silver Donating Members
  • Member For: 10y 10m 18d
  • Gender: Male
  • Location: SW Sydney

Got my thread mining hi viz gear on.

 

Anything come of this unit?

Edited by camo86T
changed word cos too much gear
Link to comment
Share on other sites

  • ...JD TUNING ADELAIDE...
  • Gold Donating Members
  • Member For: 16y 6m 29d
  • Gender: Male
  • Location: Adelaide

There's a few things available now days but the catch always is how vicious it is on the driveline and how un reliable it makes the car when using the 2steps/boost off the line features etc etc 

Link to comment
Share on other sites

  • Member
  • Member For: 11y 3m

Joe has done quite a few but like Jet said will break sh*t. Most off the shelf twin plate solid centre ceramic clutchs will not put up with it and clutch builders reccomend running sintered iron plates if you want to use a 2 step.

This is a log from my last run at the drags a couple of months ago twin ceramic discs with 2900lb of clamp and was struggling.

16c114168f8906482ab32ab427915228.jpg

Launch set at 3800rpm and leaves with about 12psi and slips hard till it gets some super hot and grabs hold. Have a another set of sintered iron plates, clutch cover and floaters now and will setup a new clutch line with a hydraulic slow release bleed.

Is good fun for powerskids though roll along at 40kmh in 4th clutch it bang bang bang let it rip instant smoke show.

  • Like 1
Link to comment
Share on other sites

  • Puff
  • Gold Donating Members
  • Member For: 9y 11m
  • Gender: Male
  • Location: South Australia

The skill lies in the tuning of the car/box.

 

A stock tuned zf equipped car just shuts the throttle when you try to brake boost it at a standstill. 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'