Jump to content

Recommended Posts

  • Member
  • Member For: 17y 8m 9d
  • Gender: Male
  • Location: Hawks Nest, NSW

hi all...

this is what I've got done to my car; capa flash tuner, eboost controler, process west stage 2 intercooler kit, crossover section & cold air induction kit. GFB BOV, 10pis waste gate actuator and bigger waste gate flap, CES Racing 3 1/2 dump pipe high flow cat and twin 2 1/2 rear muffler.

And this is what I've got to put on, just waiting to take it to the tuner; semins 60lb injectors, slim t rex fuel pump andnizpro valve springs...

has anyone got the same mods as this and how much rwkw do you have?

Link to comment
https://www.fordxr6turbo.com/forum/topic/39342-how-much-rwkw-am-would-i-make/
Share on other sites

  • Forged Member
  • Lifetime Members
  • Member For: 18y 4m 1d
  • Gender: Male
  • Location: SW Sydney

is it a BA or BF? you will get 300+rwkw but whether or not is safe depends on if its a BA or BF

  • loitering with intent
  • Lifetime Members
  • Member For: 21y 9m 20d
  • Gender: Male
  • Location: Zombie Birdhouse
  bob-jane said:
hi all...

this is what I've got done to my car; capa flash tuner, eboost controler, process west stage 2 intercooler kit, crossover section & cold air induction kit. GFB BOV, 10pis waste gate actuator and bigger waste gate flap, CES Racing 3 1/2 dump pipe high flow cat and twin 2 1/2 rear muffler.

Has the car been custom tuned to these mods ??? I hope so.

Message to all newbs, you can't just bolt intermecoolers & stuff on and go for a fang. Go bang :blink:

  • Member
  • Member For: 17y 8m 9d
  • Gender: Male
  • Location: Hawks Nest, NSW
  Buf-Phoon said:
Has the car been custom tuned to these mods ??? I hope so.

Message to all newbs, you can't just bolt intermecoolers & stuff on and go for a fang. Go bang :blink:

no it hasnt been tuned yet, its been sittin in my garage waiting for me to get some cash up so I can tune it...

  • Donating Members
  • Member For: 19y 2m 15d
  • Gender: Male
  • Location: nsw

I think u have everything covered and a respectable tuner should be able to make over 300 rwkw but.

you are going to be limited by the stock conrods and pistons.

these things get a bit close to the edge over 350 rwkw.

  • Member
  • Member For: 17y 8m 9d
  • Gender: Male
  • Location: Hawks Nest, NSW
  BFHOON said:
I think u have everything covered and a respectable tuner should be able to make over 300 rwkw but.

you are going to be limited by the stock conrods and pistons.

these things get a bit close to the edge over 350 rwkw.

how much would a set of conrods and pistons be?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'