Jump to content

New Blow-off Valve


f-wolf

Recommended Posts

  • Donating Members
  • Member For: 18y 9m 25d
  • Gender: Male
  • Location: nsw

I must agree with senna on that one the turbosmart dual port will fit in the place of the stocker and it takes 10 seconds to change from plumback to atmo.

Link to comment
Share on other sites

  • ride the lightning
  • Donating Members
  • Member For: 18y 3m 8d
  • Gender: Male
  • Location: sydney

if you look at the pics it looks like a cheaper version on the car...or is it just me?

doesnt look like the machined finish on the car

Link to comment
Share on other sites

  • Member
  • Member For: 17y 8m 24d
  • Gender: Male
  • Location: ACT
if you look at the pics it looks like a cheaper version on the car...or is it just me?

doesnt look like the machined finish on the car

Got one on Monday morning. I just but it on. No Problems @ all.

Before I fitted the Unit I pulled it apart to make sure all is well. Found some small metal bits which I cleaned out with compressed air. Also put in a bit more silicone rubber grease to be sure to be sure.

I will report back after I take the car for a Test -Drive.

2.jpg

3.jpg

1.jpg

Link to comment
Share on other sites

  • Three pedals are better then two..
  • Donating Members
  • Member For: 17y 7m 23d
  • Gender: Male
  • Location: Melbourne
All is well !!!!!!!!

:-)

Any more info F-Wolf? Hows she run/feel, any noticeable difference in performance? What about the sound?

Link to comment
Share on other sites

  • Member
  • Member For: 17y 8m 24d
  • Gender: Male
  • Location: ACT
Any more info F-Wolf? Hows she run/feel, any noticeable difference in performance? What about the sound?

I made the switch to a metal unit, because I did not trust the plastic one. If the inside of the plastic one starts to fall apart, Good Bye Turbo !

No extra noise / sound.

I did have a look at some BOV's at Autobarn. Big $$'s. A plasic one was just on 53.00 $'s.

The one I got from the States was AUD 89.59 all up. That included Air Mail.

:-)

One day I will pull the Gear Box out to replace the " Plastic Clutch Concentric Slave Cylinder " and replace it with a Metal one.

One Day. :-))

Link to comment
Share on other sites

  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'