Jump to content

Stock Internals


black/xr6t

Recommended Posts

  • Forged Member
  • Lifetime Members
  • Member For: 17y 9m 20d
  • Gender: Male
  • Location: SW Sydney

yeah, I'd be replacing them now, probly getting to the limit, but really you can have a low power output and a really bad tune and end up burning a hole in the pistons IMO

Link to comment
Share on other sites

  • Member
  • Member For: 21y 2m 5d
  • Gender: Male
  • Location: sydney

I know of a tune shop getting stock internal engines producing 370 plus rwkw. And the customers are using these cars as daily drivers and they are holding together very well.

At the end of the day it all comes down to tuning.

Link to comment
Share on other sites

  • Member
  • Donating Members
  • Member For: 18y 6m 8d
  • Gender: Male
  • Location: Sydney NSW

I wouldnt put too much concern on the power figure the dyno reads out at max rpm.

More important is the tune, how the torque is produced in the midrange. The large build up of torque in the midrange is the biggest load under boost on the motor and that can bend rods.

There's cars running in the 400s on stock internals and all is fine, then there are cars that have spat rods with under 300.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'