Jump to content

Slave Cylinder @ Water Pump


xr6 typhoon

Recommended Posts

  • Good for nothing member
  • Donating Members
  • Member For: 20y 5m 5d
  • Location: Sydney

Over the last week I've noticed a couple of drops of oil on the floor of the garage every time I take the car out. At first I thought it was the air con because all oil levels were perfect but then I got under the car yesterday and worked out it must be the Slave cylinder. I read on here that they are useless and prone to I <3 Bananas up under high heat. Also while under the bonnet I notice the coolant levels are low and see that the water pump is leaking on to the block. Anyone got any ideas what this will cost me. The car is out of warranty to.

Link to comment
Share on other sites

  • No boost, no bottle, just my foot on the throttle!
  • Lifetime Members
  • Member For: 20y 9m 15d
  • Gender: Male
  • Location: Sydney

If it is the slave cylinder it will be brake fluid, not oil and will smell different.

Mal Woods makes a heatproof one with braided lines that should fix the problem if it is the problem

Link to comment
Share on other sites

  • Member
  • Member For: 20y 8m 13d
  • Gender: Male
  • Location: Darwin, NT

I dont know about the prices of parts but the labour will cost the most. I beleave it would be around the $400 - $800 mark.

It could be leaking from the water pump itself or it could just be a gasket. They might have to clean and pressure test the system to see exactly were its coming from.

As for the slave, I have a t5 and im gussing its a gearbox out job to replace.

Bad luck mate, I hope it goes well.

Link to comment
Share on other sites

  • Good for nothing member
  • Donating Members
  • Member For: 20y 5m 5d
  • Location: Sydney
If it is the slave cylinder it will be brake fluid, not oil and will smell different.

Mal Woods makes a heatproof one with braided lines that should fix the problem if it is the problem

its definately the slave and it is brake fluid dripping on the floor and its missing fluid from its little tank

Link to comment
Share on other sites

  • Good for nothing member
  • Donating Members
  • Member For: 20y 5m 5d
  • Location: Sydney
I dont know about the prices of parts but the labour will cost the most. I beleave it would be around the $400 - $800 mark.

It could be leaking from the water pump itself or it could just be a gasket. They might have to clean and pressure test the system to see exactly were its coming from.

As for the slave, I have a t5 and im gussing its a gearbox out job to replace.

Bad luck mate, I hope it goes well.

Yea I knew I'd get raped by ford for labour. I can get a mate to do it at his work shop I just wanted it to get sorted before I go down the coast on the long weekend

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'