Jump to content

Anyone Using A Gizzmo Ibc


BFHOON

Recommended Posts

  • e-drifter
  • Member
  • Member For: 18y 2m 27d
  • Gender: Male
  • Location: Gold Coast

Used one in a mates car, there pretty average, have a bit of boost spike, the best ebc I have seen holding consistant boost levels was a profec b2, best boost controller cost $29 of ebay :spoton:

Link to comment
Share on other sites

  • Donating Members
  • Member For: 18y 9m 7d
  • Gender: Male
  • Location: nsw

heres a pic.

the button mounts on the steering wheel and can do 6 programs or 3 scrambles in a percentage each press.

either push to pass or 6 programs one per gear at the push of a button.

post-8417-1180599153_thumb.jpg

Link to comment
Share on other sites

  • Member
  • Member For: 18y 9m 11d
im using this to stop the tyres from smoking up in first gear. reducing 60ft times.

I was going to say the factory PCM is a bloody good electronic boost controller, but after reading this I am interested, so you can adjust boost for a particular gear then?

Link to comment
Share on other sites

  • Donating Members
  • Member For: 18y 9m 7d
  • Gender: Male
  • Location: nsw

yes.

it has 6 programs accessable by pressing the wheelmounted toggle button.

so you can have 8 psi on 1 10 psi on 2 and 15 0n 3 and press it after each change or

you can set up the scramble to give 5%more each press of the button, the percentage of boost up can be programmed and the time of boost up can be programed.

so I can have say 30%duty and by pressing the toggle button it goes to 35% one more press goes to 40% and then 45% there are 3 levels of boost up and as I said the time of boost up can be set.

so if u have 5 seconds boostup and u press it again before the 5 seconds is up u get level 2 for 5 seconds more. its a bit involved but I have it sorted now.

Link to comment
Share on other sites

  • 2 months later...
  • Donating Members
  • Member For: 18y 9m 7d
  • Gender: Male
  • Location: nsw

just an update on this.

I have had this in the car for a few months now and im happy with how it works.

I have the scramble setup have the boost levels set and the scramble works a treat.

the only problem I have is that 69%= 9 psi and 70%= 12 psi 71%=13.7 and 72 goes too high for my tune.

its like I need half settings to get more accurate adjustments.

my conclusion is that it works good but a better quality product may perform better. ie eboost2... but for 400 bucks its ok. :hag:

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'