Jump to content

F6 Ute, Record Broken


F6 UTE

Recommended Posts

  • Silver Donating Members
  • Member For: 19y 7m 18d
  • Gender: Male
  • Location: OZ

stroker.

you really should have been square with him and made it clear that he has not run an 11. From you wording it sounds like he uses a std clutch at the moment.

Link to comment
Share on other sites

  • Replies 29
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Guest newl
  • Guests
Nah, I didn't opt for the 3D, just getting it off the ground for longer than 30 seconds is my goal.. After that, I might progress to a little T-Rex 450 or something similar..  I only have 1hr of fly time under my belt, but I already have crashing down pat!!!

FYI, it's a little Night Ranger II  :w00t2:  cheap to fix  :w00t2:  but it's a bit quick on the cyclic for a complete novice, but meh, I like a challenge  :w00t2:

Bro-in-Law just called me an hr ago, he just did his first few barrel rolls.

He flys a Raptor .50

Do you have a sim? If not, get one (RealFlite G3 is great but TruFlite will do in a pinch). It saves the bucks on crash kits. Also, if you don't already, get the two dowel and hula hoop setup for your hovering. Once you're comfortable with figure eights going both directions (usually one direction is preferred over the other, e.g. I'm better right to left) and you can hover for a full battery you'll be right to take off the training gear. :spoton:

you really should have been square with him and made it clear that he has not run an 11. From you wording it sounds like he uses a std clutch at the moment.

Yeah, he should have called it when the BS meter went off. :)

Link to comment
Share on other sites

  • - Track Bound EVO III -
  • Member
  • Member For: 20y 2m 10d
  • Gender: Male
  • Location: Strapped in and holding on
stroker.

you really should have been square with him and made it clear that he has not run an 11. From you wording it sounds like he uses a std clutch at the moment.

I'm not that nasty.. Me, say what I think......nah..........................

He knew that I knew he was Full of Sh*t.. That's enough for me :)

And yes, he's on stocker clutch, so there's hope for you yet!!!!!!!!

Link to comment
Share on other sites

  • - Track Bound EVO III -
  • Member
  • Member For: 20y 2m 10d
  • Gender: Male
  • Location: Strapped in and holding on
Nah, I didn't opt for the 3D, just getting it off the ground for longer than 30 seconds is my goal.. After that, I might progress to a little T-Rex 450 or something similar..  I only have 1hr of fly time under my belt, but I already have crashing down pat!!!

FYI, it's a little Night Ranger II  :tease:  cheap to fix  :spoton:  but it's a bit quick on the cyclic for a complete novice, but meh, I like a challenge  :spoton:

Bro-in-Law just called me an hr ago, he just did his first few barrel rolls.

He flys a Raptor .50

Do you have a sim? If not, get one (RealFlite G3 is great but TruFlite will do in a pinch). It saves the bucks on crash kits. Also, if you don't already, get the two dowel and hula hoop setup for your hovering. Once you're comfortable with figure eights going both directions (usually one direction is preferred over the other, e.g. I'm better right to left) and you can hover for a full battery you'll be right to take off the training gear. :spoton:

you really should have been square with him and made it clear that he has not run an 11. From you wording it sounds like he uses a std clutch at the moment.

Yeah, he should have called it when the BS meter went off. :)

I have used a sim, but it got boring :tease: So it was straight to the real thing. I skipped the little bel medivac too, ( Bro in law has one for inside ) coz I had that thing hovering and wizzing round in less than a battery :spoton:

I have progressed to outside with a small breeze and am able to flog aroung for 30 seconds or so, untill the breeze takes it, usually into a bush.. When the battery's die a bit, it's damn hard to go hard right stick, or hard left stick to get control back on such a small machine..

Link to comment
Share on other sites

  • BOOST
  • Moderating Team
  • Member For: 21y 5m 21d
  • Gender: Male
  • Location: Southern Highlands NSW
His mates GTR skyline runs 11.30's because he’s a bit quicker than his mates rx7 that runs 11.60’s

His mates rx7 skyline runs 11.90's because he’s a bit quicker than his mates rex that runs 12.20’s

His mates rex runs 12.20's because he’s a bit quicker than his mates hsv that runs 12.60’s

His mates hsv  runs 12.60's because he’s a bit quicker than his mates modified GT that runs 13.00’s

His mates GT runs 13.00's because he’s a bit quicker than his mates 200sx that runs 13.40’s

…. They’re all good mates and all happy with how fast they really are!

I like your theory there brian :spoton:

I wonder what mine does :spoton:

Link to comment
Share on other sites

  • Donating Members
  • Member For: 19y 5m 13d
  • Gender: Male
  • Location: Sydney

Brian,

Do not knock the GTR's !! ... I recon the guys a liar for sure. That GTR ran 9s all day on street tyres! With a manual and a driver that could shift...

Link to comment
Share on other sites

  • Member
  • Member For: 19y 9m 4d

I thought either you broke your own record again, or youngy got that ute to stick.

I cant help it but laugh at people like this.. makes them look like an ass.

As far as we are concerned its 11.8 till someone actually runs a quicker time down the quarter mile, not next to his mates gtr.

Muzza :w00t2:

Link to comment
Share on other sites

  • - Track Bound EVO III -
  • Member
  • Member For: 20y 2m 10d
  • Gender: Male
  • Location: Strapped in and holding on

I thought either you broke your own record again, or youngy got that ute to stick.

Well, no and no..

:w00t2:

But it was kinda my intention to make that assumption for ppl..

Link to comment
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'