Original F6 Gauges?

[RIC21T]

Hi all,

Sorry this may have been posted before. I’ve have search the forum but I can't find anything on how to connect the original F6 gauges to a XR6T

Just recently purchased the original F6 gauges complete with fpv wiring loom for turbo and oil gauges and unsure where to connect them to.

Can someone advise where to connect to? (back of the gauges what colour goes were)

Where to run the wires to so the work

Thanks

Ric

[ms700]

Umm, can't be done without a lot of friggin around!

The F6 runs a factory boost pressure sender in the cooler, the standard XR6T does not run this sender.

And the oil temp sender will have to be wired in as well.

Unfortunately there is no plug that makes it all work on the XR6T, you will have to buy the two senders, and get a auto electrician to wire them in for you.

Hope this helps.

[Guest]

Umm, can't be done without a lot of friggin around!

The F6 runs a factory boost pressure sender in the cooler, the standard XR6T does not run this sender.

And the oil temp sender will have to be wired in as well.

Unfortunately there is no plug that makes it all work on the XR6T, you will have to buy the two senders, and get a auto electrician to wire them in for you.

Hope this helps.

←

The sender for the boost gauge was attached to the steel pipe under the rhs headlight.

[RIC21T]

do u think I can do the same thing with the oil sensor