Jump to content

Overheating Problem


Mals BA XR6T

Recommended Posts

  • SLOJAM, Gone but not forgotten
  • Lifetime Members
  • Member For: 22y 3m 5d
  • Gender: Male
  • Location: Outer east - Melbourne
Did any one read anything about this.. what's the go?? Is it fixed?? Does anyone actually *know* what happened :unsure:

Just did a Yahoo search and no hits?? Where did you hear this?

Link to comment
Share on other sites

  • some guy...
  • Member
  • Member For: 22y 3m 2d

Wheels were fanging one of the XR6Ts around Ford proving grounds when it overheated and shut off two cylinders I think. It had to do something with the computer programming, not hardware issues.

According to Geoff Polites and Wheels, it's been rectified an all XR6Ts.

Link to comment
Share on other sites

  • SLOJAM, Gone but not forgotten
  • Lifetime Members
  • Member For: 22y 3m 5d
  • Gender: Male
  • Location: Outer east - Melbourne
Wheels were fanging one of the XR6Ts around Ford proving grounds when it overheated and shut off two cylinders I think. It had to do something with the computer programming, not hardware issues.

According to Geoff Polites and Wheels, it's been rectified an all XR6Ts.

Can you give us a link to an article?

Link to comment
Share on other sites

  • Member
  • Member For: 22y 2m
  • Gender: Male

The ECU shut the engine down on 2 occasions because of an "oil temperature protection mode" issue

Ford established the problem was due to a lack of foresight during the development of the engine oil over temperature protection strategy software written for the cars engine management computer, in the month following the incident Ford engineers developed and validated an update. XR6 Turbos already in the hands of customers will have the fresh code flashed into the ECU at the 3000k service.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'