Jump to content

WA Spotted & Chit Chat Thread


cunners

Recommended Posts

  • Donating Members
  • Member For: 13y 8m 10d
  • Gender: Male
  • Location: Baldivis, Wait Ages.

The most time consuming part is removing the collets and reinstalling them. They either fall in first time or take 10mins ea. Make sure you use some quality rag to cover the oil drain holes in the head so none escape.

I'd strongly suggest you get a 1/4 drive battery powered impact driver to remove and install the tool retainer bolts and a rechargeable rattle gun or ratchet to run the press tool bolts down. Saves bulk time. Don't use a heavy air powered gun or you'll mash out the tool.

Thanks for that mate! Will defiantly keep that in mind. I have a spare block all together on stands at home so I'll have to practise. I need a new air compressor. I can't imagine needing much air?

Link to comment
Share on other sites

  • Member
  • Member For: 16y 6m 10d
  • Gender: Male

It would be good to get a price from them also Luke. The reason I wanted nolathane is that they have the part that has the bushes already in it. (Complete new lower trail arm and front control arm)

I need to get new:

rear lower trail arm bushes

Front control arm inner bushes LH and RH

New ball joint to front LH

Do thet have control arm and the trail arms ready as a kit to install or just bushes? I dont have a 12 ton jack or what ever is required so that's the only thing holding me back from doing it

Edited by TaHa
Link to comment
Share on other sites

  • Member
  • Member For: 11y 11m 25d
  • Gender: Male
  • Location: Perth

I gotta change out my washer fluid. Smells like complete ass. I think when xft topped it up either the chemical they put in has mixed poorly with what was in there or ita just water that has since gone poorly.

Link to comment
Share on other sites

  • Donating Members
  • Member For: 12y 4m 25d
  • Gender: Male
  • Location: Perth, SOR

Just seen a classic.

A car turning off Freeway North bound onto canning bridge towards Burswood.

Did a 90 deg turn into bus station lane, smashing head on with a bus.

  • Like 2
Link to comment
Share on other sites

  • Member
  • Member For: 11y 11m 25d
  • Gender: Male
  • Location: Perth

Lol nice one.

Just spoke to an exhaust place regarding the centre muffler removal thing I was on about a while back. He was telling me that if u go cat back it wont require a tune or anything, again I thought it would do... can anyone confirm ?

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'