Jump to content

WA Spotted & Chit Chat Thread


cunners

Recommended Posts

  • 570Nm @1800rpm
  • Donating Members
  • Member For: 21y
  • Gender: Male
  • Location: Perth, WA

Thanks Luke. I thought the same about oil light, too low revs for it to build any oil pressure.

What about intake manifold to head?

Is the upper/lower manifold gasket just a paper gasket like the tb to manifold?

I will go over and check both as you suggested.

Is there any way to test the crank angle sensor?

Cheers

Link to comment
Share on other sites

  • Member
  • Member For: 11y 2m 21d
  • Gender: Male

Hate to say it mine started to splatter like no fuel then no oil pressuer

I hope it only a crank sensor but when I towed it to xft and diagnosed

The problem it was oil pump good luck just give Simon a ring

Link to comment
Share on other sites

  • 570Nm @1800rpm
  • Donating Members
  • Member For: 21y
  • Gender: Male
  • Location: Perth, WA

Haha nah mate this one wont be going to Simon. Its not my car but my brothers BA that he is trading on a new car, just trying to help him out before he has to get it towed.

I'll have to go there and have a better look at it. The other night I just happened to have my scanner in the car so just checked for fault codes.

Cheers

Link to comment
Share on other sites

  • Moar Powar Babeh
  • Lifetime Members
  • Member For: 18y 11m 30d
  • Gender: Male
  • Location: Perth

I seriously doubt a non turbo ba would have eaten a set of gears.

Cas would throw bulk codes. It could be the intake to head gasket but Start with the easy ones. Upper to lower is a metal shim gasket.

Link to comment
Share on other sites

  • skids
  • Donating Members
  • Member For: 11y 8m 25d
  • Gender: Not Telling

Gotta hate it when alternators fail on a little trip between your house and a mates. The pulley seized. If yours is noisy, I'd suggest getting it done.

It was only booked in friday!

Edited by johnxr6t
Link to comment
Share on other sites

  • Member
  • Member For: 17y 8m 29d
  • Gender: Male
  • Location: PERTH WA

1 sleep to go until I pick my car up after 10 months of it sitting in the garage collecting dust.

New turbo, injectors, surge tank and fuel pumps, E85 tune and most important new oil feed line.

Just hope its not raining tomorrow!

  • Like 1
Link to comment
Share on other sites

  • Hench, but no longer shredded or tanned.
  • Member
  • Member For: 17y 5m 25d
  • Gender: Male
  • Location: Canning Vale, W.A

Hehehe you'll love it. Just the induction noise is amazing in itself.

Also long time no speak mate, I take it my under headlight typhoon intake is long gone? Aha

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'