Jump to content

WA Spotted & Chit Chat Thread


cunners

Recommended Posts

  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 17y
  • Gender: Male
  • Location: Probably above atmospheric pressure

coolant expansion tank blew to pieces

Sick! Not so good for him though... @_@

Link to comment
Share on other sites

  • Donating Members
  • Member For: 14y 5m 3d
  • Gender: Male
  • Location: Perth,WA

fg prem pack parcel shelf

20130916_174005_zps012be58e.jpg

and as promised (insert joke about milshakes bringing boys to yard)

20130914_135349_zpsb1b85baa.jpeg

Those of you that invested in the pwr zf heat exchanger group buy can sleep easy.

Edited by MurdoK
Link to comment
Share on other sites

  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 17y
  • Gender: Male
  • Location: Probably above atmospheric pressure

OMFG that is horrific. Poor guy!

Manual, pfft. N bombs FTW... gearbox says: :nukem:

Link to comment
Share on other sites

  • 570Nm @1800rpm
  • Donating Members
  • Member For: 21y 2m 3d
  • Gender: Male
  • Location: Perth, WA

Anyone seen fault code P1131 on a BA (petrol 6cly) before?

Car started to develop a misfire and was not driven for a week. Now wont start, she cranks over spits and farts but wont fire.

Fuel pump primes but is guess that does not rule it out.

A faulty O2 sensor would not cause the car not to start would it? Also minor vacuum leaks would not cause it to not start would they?

I am thinking crank angle sensor or no fuel.

Any tips from the B series experts welcome.

Cheers

Edited by XtRmn8
Link to comment
Share on other sites

  • Moar Powar Babeh
  • Lifetime Members
  • Member For: 19y 2m 1d
  • Gender: Male
  • Location: Perth

P1131.pdf

Does if have any vacum leaks? These will give you issues.

Car should start with a dodgy 02 as they start in open loop and don't reference the O2 sensor until a preset time/coolant temp.

Link to comment
Share on other sites

  • 570Nm @1800rpm
  • Donating Members
  • Member For: 21y 2m 3d
  • Gender: Male
  • Location: Perth, WA

Thanks for the info Luke.

It is possible that it may have a vacum leak. It would have to be pretty serious leak for it to not start though? Also it would be on intake side as well?

What are the most common places for these to leak? Intake manifold I would guess?

Brother did mention oil light is on and stays on for a couple of seconds after cranking the engine. But was not on when it started to play up.

Thanks

Link to comment
Share on other sites

  • Moar Powar Babeh
  • Lifetime Members
  • Member For: 19y 2m 1d
  • Gender: Male
  • Location: Perth

Oil light is probably staying on a revs are too low. I would look at throttle body to manifold and upper manifold to lower manifold (intake) as the first possible cause. Pretty common for them to leak.

It they leak enought the MAP sensor will see this a open throttle condition and the PCM will add fuel (and cause over fueling)

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'