Jump to content

WA Spotted & Chit Chat Thread


cunners

Recommended Posts

  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 16y 11m 17d
  • Gender: Male
  • Location: Probably above atmospheric pressure

Running stock crossover and joiner?

Link to comment
Share on other sites

  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 16y 11m 17d
  • Gender: Male
  • Location: Probably above atmospheric pressure

I'm running stock crossover and never had that issue, clamps are crappy too. Tried to find new ones but the ones at bunnings and covs aren't thin enough. Ford genuine only covs suggested but I know they would be five bucks a pop. Is your joiner cracked?

But yeah p!ss the crossover off is the real fix...

Edited by -SteveR-
Link to comment
Share on other sites

  • Member
  • Member For: 11y 11m 16d

Anyone had much dealings with nuford?

Car is there for warranty, and just wondering what to expect when I start asking questions about the repair work?

Getting the cylinder head, and oil pump replaced, but service desk suggested I can't get a report until after its all finalised. Won't do much good then if I find out after that the sump was full of fillings, and the pistons had contacted the valves, but the motor is all back together.

Link to comment
Share on other sites

  • Moar Powar Babeh
  • Lifetime Members
  • Member For: 19y 1m 18d
  • Gender: Male
  • Location: Perth

I was one and only dealing with nuford was when the used liquid nails (or something similar) and a bit of rag to re secure my mates BA GT handbrake cover.

If your car wasn't already there I would say runaway, but to late....

Link to comment
Share on other sites

  • Member
  • Member For: 12y 1m 26d
  • Gender: Male
  • Location: Perth

Brand new seal and snapped original ford one found one like 2 mill wider but still same thing, seen one in a mag where had like two tensioning points ? But every were I ask no one ever here of it, apparently coz two much pressure or something ?

Link to comment
Share on other sites

  • Member
  • Member For: 12y 1m 26d
  • Gender: Male
  • Location: Perth

hay wondering what places people have had there work done on there turbos? was it good and whos not. Also has anyone used or using plazmaman products are they good?

Link to comment
Share on other sites

  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 16y 11m 17d
  • Gender: Male
  • Location: Probably above atmospheric pressure

Plazmaman coolers have a good rep on the forums yeah, you only need to read a few of the "which cooler is best" or build threads to see what people think.

Not sure about turbo work as mine is stock, I'll let others chime in on that one.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'