Jump to content

WA Spotted & Chit Chat Thread


cunners

Recommended Posts

  • Donkey Dick
  • Member
  • Member For: 14y 7m 27d
  • Gender: Male

Yep, manual.

4-5k, I have 3" cat-back zorst with a single straight muffler, so I was jut going to add onto that. Other than that, it's pretty stock. I was thinking Injectors (60lb?), pump, F6 lower snorkel, 4" dump, high flow cat, IC & piping. Tuned by Simon. What boost would I need to run for 330 do you think?

Was also planning to get a Malwood option 3 in as soon as possible as my clutch is starting to slip second a little. :3gears:

3" cat-back will hold you back.

Put stock exhaust back on with Ballistic 5" bodied cat for the most cost effective solution, or buy a SMB 4" Turbo Back System if you want it done right :thumbsup:

Any of you girls racing at Expensive Daewoo v Ford on 25th April? Keen to line up some Turbo Taxi's in the Calais :tonguepoke:

Link to comment
Share on other sites

  • Moar Powar Babeh
  • Lifetime Members
  • Member For: 19y 1m 23d
  • Gender: Male
  • Location: Perth

Deans having a little holiday so wont be able too reply.

From what I gather Calais has some big cube motor and trans, transplant Nizpro phoon was sold too Arronm's Son (whos name escapes me but is a member on here)

Link to comment
Share on other sites

  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 16y 11m 21d
  • Gender: Male
  • Location: Probably above atmospheric pressure

Nizzy Phoon is sitting at XFT last I saw. All is not well, turbo died 1/3 of the way driving back from over east :(

Link to comment
Share on other sites

  • 570Nm @1800rpm
  • Donating Members
  • Member For: 21y 1m 24d
  • Gender: Male
  • Location: Perth, WA

Yep, manual.

4-5k, I have 3" cat-back zorst with a single straight muffler, so I was jut going to add onto that. Other than that, it's pretty stock. I was thinking Injectors (60lb?), pump, F6 lower snorkel, 4" dump, high flow cat, IC & piping. Tuned by Simon. What boost would I need to run for 330 do you think?

Was also planning to get a Malwood option 3 in as soon as possible as my clutch is starting to slip second a little. :3gears:

Tom, have a look at this in the Classifieds section:

http://www.fordxr6turbo.com/forum/classifieds/ad/1274-xcal3-pw-cooler-60lb-injectors-atomic-valve-springs-more/

I don't think you will need valve springs to get 300rwkw in BF Mk2 but might as well have them in case you do need them. All you need to get is a fuel pump and an actuator.

As other have said the 3" over the diff exhaust is rubbish and flows less than the stock system. Put the stock one back on or get an after market twin 2.5" that will bolt straight up.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'