Jump to content

Quarter Mile Times Discussion


geea

Recommended Posts

  • Faster than any BTA,XTC,Autotech, Nizpro and Tunehouse car
  • Member
  • Member For: 21y 3m 13d
  • Location: D SHIRE!
new pb  11.59 @120 mph  1.70 60 ft I did run it up on a Dyno with this tune, but if you want, post what rwks, and NM you think it would have had to run that time and that mph,

I just thought it would be good to see peoples estimates,

If its Edit I would say 310-315 rwklw :spoton:

Link to comment
Share on other sites

  • Donating Members
  • Member For: 19y 22d
  • Gender: Male
  • Location: Sydney

Well done guys .. some pretty good times.

My car is finally getting the auto rebuilt and fuel pump put in and I will hopefully join the 11 second club ....

I ran 12.3 @ 112MPH, 1.9 60 footer, standard 17" dunlops on the 31st May at WSID.

I do not think that the car will mabe BVWII but I might fly down for a few days.

Link to comment
Share on other sites

  • Seriously Flukey Member
  • Donating Members
  • Member For: 20y 6m 14d
  • Gender: Male
  • Location: Melbourne
Well done guys .. some pretty good times. 

My car is finally getting the auto rebuilt and fuel pump put in and I will hopefully join the 11 second club .... 

I ran 12.3 @ 112MPH, 1.9 60 footer, standard 17" dunlops on the 31st May at WSID. 

I do not think that the car will mabe BVWII but I might fly down for a few days.

What power did you have for your 12.3?

Link to comment
Share on other sites

  • Donating Members
  • Member For: 19y 22d
  • Gender: Male
  • Location: Sydney
Well done guys .. some pretty good times. 

My car is finally getting the auto rebuilt and fuel pump put in and I will hopefully join the 11 second club .... 

I ran 12.3 @ 112MPH, 1.9 60 footer, standard 17" dunlops on the 31st May at WSID. 

I do not think that the car will mabe BVWII but I might fly down for a few days.

What power did you have for your 12.3?

About 300rwkw but I have had problems with the auto slipping going from 2nd to 3rd ... I ran a 12.2 with heaps of wheelspin late last year then broke a CV.

The car should run 11s with the box upgraded

Link to comment
Share on other sites

  • Donating Members
  • Member For: 19y 3m 29d
  • Gender: Male
  • Location: Canberra ACT

new pb  11.59 @120 mph  1.70 60 ft (must have streched the standed stall a bit)

I did run it up on a Dyno with this tune, but if you want, post what rwks, and NM you think it would have had to run that time and that mph,

315rwkw I think, depends on the tune.

My car makes around 290rwkw, but makes about 275 @ about 3500rpm.

It hasnt run down the quarter, but has a built Kewish box and stally, and is nice to drive on the street!

Link to comment
Share on other sites

  • Member
  • Member For: 20y 4m 9d
  • Gender: Male
  • Location: Mackay NorthQueensland

well you both are close.

it made 300.9rwks and just over 1000 NM

but I think about 10 kws gets robed by being in second and the torque will be inflated a bit, someone else that knows about dyno's can coment on that

I had it drop back to about 284kws on gear change.

I will get the slip and dyno printout scaned and post them together.

David

Link to comment
Share on other sites

  • Member
  • Member For: 18y 3m 7d
been reading some of everybodies times, they are very impressive  remembering the car ways over 1700 kgs!!

I see everybody has modded cars here, and yeah I know it all depends on driver, weather contidions, track quality etc....

but what have peopl;e generally done and mechannically standard xr6 turbos??

manual auto and 6 speed auto if anybody has tried yet..

spanx

my stocky did a 13.7@101.01mph and a 2.1 60' no mods at all and very low on tyre tred.

Link to comment
Share on other sites

  • 3 weeks later...
  • Member
  • Member For: 18y 3m 10d

Hey All,

Took my bog stock 4 speed auto to willowbank last week.

Managed a 14.3 @ 99mph. meh.

I was using performance mode and wanting to switch gears myself to stretch it, but when in 2nd it changed to 3rd on its own way to early (ie before 4000rpm) .

Anyone else experienced this problem?

cheers

mick

Link to comment
Share on other sites

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'