Jump to content

King Springs


AzZaMaTaZ

Recommended Posts

Guest Rota_Motor
  • Guests

I emailed king springs, and this is an excerpt from the return email I recieved.

We have King Springs Part No KFFL-57 (front) & FOR-808 (rear) to lower your vehicle approximately 45-50mm from factory std height. Hub to guard approx 345mm front and 350mm rear.

These coils are designed with an increase in spring rate of approximately 25%.

RRP is $ 155.00 + GST per pair front.

RRP is $ 330.00 + GST per pair rear.

Please contact the following King Springs Distributors for a price & availability:

Autobarn, AutoPro, Checkpoint, Fulcrum, Repco, Supercheap, Bursons & most leading suspension specialists.

that is 4 new springs, not just reset leaves, I think these prices are quite reasonable, and when I get the spare cash will be getting these for my ute.

Link to comment
Share on other sites

  • 4 months later...
  • Member
  • Member For: 19y 6m 10d
  • Gender: Male
  • Location: Victoria

paid 400 all up new 3" lowered leafs and 2.5" for the fronts I installed my self

these are king springs I actually paid 350 for the lot but had to buy the leaf spring bushes from ford so it works out to be 400 all up.

Link to comment
Share on other sites

  • Member
  • Member For: 20y 4m 21d
  • Location: Sutherland Shire, Sydney
paid 400 all up new 3" lowered leafs and 2.5" for the fronts I installed my self

these are king springs I actually paid 350 for the lot but had to buy the leaf spring bushes from ford so it works out to be 400 all up.

<{POST_SNAPBACK}>

Do you have to replace the bushes when you install the new leaves? I will be doing the same thing next weekend, so any advise you could give would be appreciated.

From memory I read that Trough Lolly used nolathane bushes. Are these the same as the ford ones or better?

Thanks

Chris :fool:

Link to comment
Share on other sites

  • Member
  • Member For: 19y 6m 10d
  • Gender: Male
  • Location: Victoria

I only replaced the bush towards the front(front of car) of the leaf as this has to be pressed in I just got ford to press them in for me.

that the only drama I ran into

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'