I had the F6 in a thousand pieces today trying to fit a saggy front bar after collecting a serious spoon drain. I knew I was up for bar mounts LH and RH and lost a few scrivets but that's all sorted. I have found a completely shattered radiator support bar - its broken in 3 places. and whole 6" section on the LHS that ties to the fender is completely missing and I've discovered a bit of dodgy repair work...lots of sikaflex....LOTS of sikaflex So someones done the dodgy and had a crack at repairing it themselves and left me with a problem - I can't install my new cooler till the rad-support is replaced. How does this thing come out? is seems to be fused to the metal upper support (where the striker etc attaches) but the whole rad-support is made of a hard plastic. I would like to do it myself to save the $$$ it will cost to get a crash repairer to do it, I don't wish to make an insurance claim either. But after pricing the parts, its looking bad ($455 rad-support, $300ea for headlights...the list goes on) Has anyone here ever done it? care to share? thanks in advance.