Search the Community
Showing results for tags 'limp'.
Found 2 results
-
02 ba turbo ute in limp mode Parked up ute put in new injectors and fuel pump. Went to tuner ute was in limp mode was fine before installing the items. In process if changing fuel pump broke a abs wire and soldered back together. Auto elec said abs is all reading right. car will go up to 110kph stays in 3rd no speedo all prnd flashing. has Canbus fault on scanner and sometimes speed sensor have Replaced abs pump,tried a engine ecu (only plugged in not programmed to start) replaced fusebox. Check wiring. Reset code on gearbox. Cleaned gearbox wiring. please help this has been a pain for months and no one can find the issue
-
So I've just installed a 4" Dump - 5" Cat in preparation to be Tuned on Friday, Problem being I need to drive 6hrs to get to the tuner. Everyone says this will cause Overboost so I took it for a drive to try and activate Limp mode so I would know when it happens and what I'm dealing with rather than finding it all out in the middle of woop woop. Boost seemed to peak at 13psi (OBDII-android device) gunning it in 2nd or 3rd but once peaked it wouldn't boost past 3psi until the engine was shut off, no codes or lights. Made all the regular noises and ran Perfectly but with the power of an n/a xr6 and without the push back into the seat. Is this what normally happens or am I not thrashing it hard enough? Doesn't seem so bad. Also has full exhaust, turbo side intake, stage2 PW Intercooler. Never Tuned
