Search the Community
Showing results for tags 'King springs'.
Found 3 results
-
Hey Lads, New to this site, looks awesome Just over 12 months ago I traded in my 2011 FG2 XR6 N/A in on a VF2 SS. Very bad decision and long story short I'm now back to a 2013 FG2 XR6 N/A. My old XR6 was an ex Highway Patrol in WA, which meant it was a tad lower than stock. I want my new XR6 to be the same as it was a good height for it to look good and just a bit different however it wasn't too low. I do a lot of country driving for work and one of the highways is terrible I think I'll bottom out if I get it too low. I have a feeling my old falcon was only lowered in the back however I remember I always had to go sideways down kerbs because the front would always scrape so I'm not too sure. I know it had king springs on it but I don't know if it had upgraded shocks too or not. My old one looked mean from the back and you could tell the difference between mine and a stock one quite easily. A setup I have been thinking about is the King springs Lowered EHD Coils KFRL-68SSLHD? without shocks just in the rear and leave the front? I think they're meant to be 30mm lower than stock? What you guys think? I would like to avoid the shocks if possible just because I'm not looking to spend heaps. Just chasing some advice on what the setup may have been and whether I do need to get shocks as well or not. Cheers Guys
-
Hey guys, So just bought a set of king springs for my BF MK2 XR6 and realised that I've accidentally ordered BF MK1 springs. On king spring's catalogue they say theres a difference in the seat or something but I've read else where that there's 2 positions on it so it might work. I was wondering if someone could shine some light on this? I've messaged the ebay guy asking for a swap but if these working for mine then it'll save me a lot of effort. These are the springs I bought: http://www.ebay.com.au/itm/FORD-FALCON-BA-BF-XR6-SEDAN-2002-6-2007-SUPER-LOW-50mm-F-R-LOWERED-SPRINGS-/331989619360 Thanks
-
Hi guys sorry if this has already been posted I just couldnt find them, I dont know what size king springs I should use on the front of my ba xr6 turbo, I dont want it slammed just want it above the tyer so it looks nice, im not sure if sl or ssl , iv just put sssl and there way to low any help would be much appreciated , iv got 20s with 225,35,20 rubber on them
