Search the Community
Showing results for tags 'DIY'.
Found 3 results
-
Here is a photographic guide how to change the interior light globes in your BF XR Falcon. Firstly, here is a link to where I got my globes from. Very fast postage and very nice product. http://www.ebay.com.au/itm/FORD-BA-BF-XT-XR6-XR8-TURBO-F6-INTERIOR-LIGHT-KIT-WHITE-/220755235240?pt=AU_Car_Parts_Accessories&hash=item33660991a8&_uhb=1#ht_5549wt_986 ----------------------------------------------- Reading Lights ----------------------------------------------- Remove the housing by grabbing from one corner and pulling down until clips release. Remove housing and unclip power from the back. To remove lights, grab and rotate anticlockwise Remove globe by simply pulling straight out. Replace globes with your desired colour LEDs Plug the power back in and push the housing back into the roof until it clips in. Done. Before & After ----------------------------------------------- Main Cabin Light ----------------------------------------------- Start by removing the plastic cover. Now remove the globe, be careful, this is really tight so try and loosen the clips a little before pulling on the globe. Replace with the desired colour LED. Replace plastic cover. Before & After ----------------------------------------------- Rear Seating Lights ----------------------------------------------- Remove by using fingers or a flat head screw driver to open from the drivers end of the housing. Unplug from power for easy globe removal These globes are bayonet type globes, so just push and rotate. Close up of the globe and housing. After completing all globe changes. Thanks guys
-
Here is a photographic guide to help you change the colour of the Ignition Illuminator on your BF MkII XR6. Here is a link to the globes I used from eBay. You need a T4 Wedge globe. http://www.ebay.com.au/itm/130582917218?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649 Starting with the stock orange light you can see here... Under the steering column you will see 3 screws, philips head. Remove all 3 of these. Now the bottom and top halves will separate on the column and you can completely remove the bottom half. You will need to unplug this power lead. (you can do this first or second) Here is the screw that will release the housing so you can proceed to the next step. Again philips head. Now you will be required to remove the following 4 clips to open up the housing. This is a bit tricky but it will help with a flat head screw driver. Here is the T4 Wedge Globe, using a flat head, twist and remove. Replace with your desired colour LED Now return to the car and plug it back in, test. Once confirmed it is working, place the housing back over the ignition, screw back it in and replace the steering column cover, screw in and ensure the top half is in the correct place. After Cheers guys
-
-
- 2
-
-
- power steering bleeding
- bleeding
- (and 5 more)
