simonhoare

someone been jacking it via the crossmember tab???

yeah you can but it,ll run like and frizzle the cat

ii am pretty sure the size you have listed for the process west cooler is the core size ....any one?

sorry just read your post again ... you can supply pipe ...what is cost of cooler and pipe????

IAM pretty sure mine are coming from the vent tubes which are molded into the back side of the dash,removal to get to them..the last week I've been more passenger than driver.

or loose baffles

ive tried all of the above I musnt be the only one, ok next week ill pull the f..cker out

how many other people out there have got annoying creeks behind there dash,mines in the LH top corner on bumpy or uneven roads ,how did you fix them?? Ive tried every thing but remove the dash!!

the six speeders should have come out with these lower numbers brian or have been an option!!!!!

you dont need to remove the battery to lube the solenoid just the two intake pipes!!! and id do the turbo oil filter once the car woz relatively new and then every 20- 30000ks ,depending on service intervals...

you use a soldering to heat the heads of the screws up or careful use of a heat gun when the engine is colder.

nice ....looks good be intersting to see what the afr are like on the tune..

do you have any 8psi figures????

is that fist generic tune or capas???

that is on petrol

welcome to the site robert....is it stock? if so ,sounds like its over boosting!! more info!!

It was a stinking hot day here today and especially at wacol.You could be right paul.It does seem high for a stocky ← yep it was hot at Archerfield too. We tuned a Bf auto today and got 265 rwkw with standard cooler on 10 psi. ← boost...last quote.

sorry didnt read end of last post!!!

remove the bumper..

behind or below??

unless the specs have just changed?? :spoton:

Does it though? Or has the 'recommendation' simply changed? When I enquired of FPV about what oil I should use in my F6, they said that Ford/FPV will use different products over time (depending on cost, and new products that come out). As long as you stay within spec, you're ok. Some dealers use Mobil for servicing, others use Castrol for example. All off the shelf stuff, except for the run-in oil perhaps. ← I can assure everyone this is correct. Trust me. ← ba bf xr6t oil weights are the same for both ford recomend WSE-M2C905-A , R1-340 15W 40 , same as the gas eng, f6?? :spoton:

that's it you need a smick fitting dummy shaft and persiverence and that first hit make it a good one!!