viking

yes I am going to stay with 18" I have sold the cheap BSA and going to order my new wheels real soon. thank for your help.

The vibration was worse without the hub rings.

When I put the stock rims on the vibration dissappears. I have $300 Yokohamas all round.

Yes!! they have been balanced properly. I got them to recheck it.

I am hoping to get 9" all round

HELP!!!!! I have 18" BSA wheels fitted to my BFII XR6T, I am getting alot of vibration in the steering wheel and in back of the car between 80kph plus since they been fitted. does anyone else have this problem with the BSA Wheels? I have installed the proper hub rings and alot of places have looked at this problem but cant seem to figure out the issue. Is it that the BSA Wheels are bad quality? and may be hard to balance right. I am seriously thinking of getting the Foose(MHT) Nitrous 18" fitted(are they any good). will the Foose Wheels give me any issues? because I dont want to go back to the boring stock rims.

What offset would be best for 9"

I am thinking of importing some wheels from the USA, Can anyone tell me the bolt pattern, offset and width of the wheels for a BF XR6T. I am thinking of 18". Cheers

Hey guys, I have started to notice that my car wont start first go sometimes, I turn the key and all the lights come on, on the dash but nothing happens. After a few goes the car will then start. This problem is noticable when I have been driving the car for a while then I pull over for half hour or so. It seems to start fine first thing in the morning or when motor is cold. The only mod I have is an edit, I flashed it back to factory settings and it seems to start fine. Does anyone know what the problem might be?

Hey guys I havent been in town of late, but just got back recently and a few days ago I noticed an xr6 with Angel Lights (like the ones of the BMW) is there a install kit available or someone that can do this? I love the look it gives.

Thanx guys

I have a 2006 BFII xr6turbo, I noticed the other day a hissing niose coming from the car when accelerating, I dont even need to be accelerating hard. It doesnt seem I have lost any power from the turbo. What could this be?

I am thinking of getting some after market rotors. I was only going to replace the front rotors but not the callipers (I dont want the abs to be affected). Should I get slotted rotors or cross drilled rotors, and where in Sydney is the best place to get this job done? I have a BF II

It sounds a bit low. My T makes 162rwkw with just a Capa Flash and Dyno tune, with 95 Octane. everything else is stock.