alpha2sam

Hi, You wont need the plenum for anything under 400RWKW so get the kit minus the plenum. Buy the IC and single pipe and then get a seperate cold air box and piping. Over 400RWKW have a look at the Atomic FG intake upgrade for the B series falcons.

Hi, Nice work. YTou have used low priced speakers, what is the efficiency like, compared to standard? Do you have to turn the volume up higher than the standards to get the same noise level.

Hi, I have a BF Typhoon, that is standard at the moment. I can hear the injectors tapping away like a VN commodore. On the holdens it was an issue with the fuel pipe not being secured and rubber isolated. Has anyone had this issue. Is there a fix?

Hi, I have a BF Typhoon with climate control. When I first start the car and take off (usually from cold), I can hear a pump noise, sounds like it is filling the vacumm pipes for the Climate. Is this normal?

Hi All, I am fitting an APS IC which takes up the space used by the factory power steering cooler. I have two options: (I) Relocate the standard cooler (ii) Buy a smaller aftermarket cooler Where is the best place to re-locate the power steering cooler? My preferred option is to retain the original unit, but where do I locate this?

Hi, I own a very neat Typhoon. It has the standard interior, which is nice but a little drab. I can get a the leather Typhoon upgrade and then I sat in an GT-P (nice seats). Gentlemen, am I destroying the heritage and potentially the re-sale value by putting in an GT-P interior. Should I just get the leather Typhoon interior? Your thoughts please. One thing I will be doing is upgrading to 6/4 pot brembo's. I think that will satisfy the originality needs and give a nice upgrade.

Where you getting 380RWKW with the same performance bits ie plazman plenum and IC. Was 450RWKW achieved on pump fuel or e85?

Hi, Big difference in power with a plenum change. What set up were you running, I am about to embark on my upgrade path using APS gear.

He still achieved good power on 98 Octane, similar to what others are getting with a Plenum. What's your setup?

It also proves that an after market plenum is not required to achieve that power level.

Very clever my friend, I must say I am very impressed!!!!!!! Have you got a photo of the lid that you made for the top? How does it it perform compared to the bottom setup (open aiur filter)?

Does anyone in Melbourne have an APS Phase III Kit in their Xr6 Turbo or FPV. Would like your opinion's please of the results.

Neat Car What's the fuel economy like now?

So you saying you gor the standard box to fit on the other side, with some major butcher mods. Any photos?

Hi, Did you do the service yourself? Was it easy to do without the hoist?